Idiomas disponibles
Idiomas disponibles
Seat installation and removal
The seat can be installed either forward or rearward facing. Place the seat in
the connectors located on the frame of the stroller (fig. 7). Proper installation
of the seat on the frame of the stroller will signal a click. Make sure the seat is
installed correctly.
To remove the seat from the frame of the stroller, press the two release buttons
consecutively until you hear a "click" (you do not need to keep these buttons
pressed). Lift the seat up (fig. 8).
Fastening the harness:
Connect the shoulder straps (A) to the waist straps (B) then slide them into the
buckle. A characteristic "click" will indicate that the straps are properly fastened
(fig. 9). When using the product, also fasten an additional crotch strap on the
headband (fig. 10).
Harness adjustment:
A.
Height adjustment:
To adjust the height of the shoulder straps to your child's height, slide the strap
buckles out of the holes in the seat back. Then put them through the appropriate
holes and turn the buckle (fig. 11).
B.
Length adjustment:
To adjust the harness, move the adjustment handle up or down by pulling or
releasing the strap (fig. 12).
Rotating wheel lock button
To lock the wheel, move the lock button to the left. To unlock the rotating wheels,
move the lock button to the right (fig. 13).
Locking mechanism
Press to lock the wheels and stop the stroller. Lift to unlock (fig. 14).
Footrest adjustment
To lower the footrest, press the buttons on either side of the footrest, then push
‑ 15 ‑
EN
