Idiomas disponibles
Idiomas disponibles
The towel warmer radiator must be used only for the purpose described in the manual. In particular, children must not play with the appliance.
Do not apply on the towel warmer radiator accessories other than those prescribed or recommended by the manufacturer.
Connect the radiator to the mains power supply only after it has been fixed to the wall.
Children under 3 must be kept at a distance unless under continuous surveillance.
Children between 3 and 14 years of age and persons with reduced physical, sensory or mental capacities, or who lack experience or the necessary
knowledge can use the radiator on condition that it has been positioned or installed in the normal position contemplated and they have been instructed
and trained in its safe use and are aware of the potential risks.
Children under the age of 14 must not connect the power plug, nor adjust or clean the appliance.
Children and persons with reduced physical, sensory or mental capacities, or who lack experience or the necessary knowledge must not perform
cleaning or routine maintenance of the towel warmer radiator.
It is absolutely prohibited:
To power the heating element control before having checked the correct installation of the thermostat on the towel warmer radiator.
-
To cut the power supply cable to disconnect the appliance
-
To damage the power supply cable. If the power cable is damaged the complete electric heating element must be repaired or replaced by the
-
manufacturer or by their technical assistance service, or by a qualified person authorised by the manufacturer, so as to prevent any risk.
WARNING:
Before powering the electric heating element, make sure that the towel warmer is completely filled with water.
-
During operation of the electric heating element, the complete filling of the towel warmer with water and the free expansion of the internal liquid
-
content must be constantly guaranteed, so the valve and the lock shield must never be turned off at the same time.
DURING OPERATION, THE RADIATOR PRESENTS HOT SURFACES, SOME PARTS CAN GET VERY HOT, AND CAUSE BURNS UNLESS
PARTICULAR CARE IS TAKEN. Particular attention should be paid to the presence of children and vulnerable people
During operation it is normal for the last two pipes at the bottom and the first one at the top to remain lukewarm.
-
Only fabrics washed with water can be dried on the towel warmer).
-
Do not use corrosive or abrasive products or solvents to clean towel warmer) or the plastic parts that contain the electrical parts.
-
The use and operation methods are inserted in the radio control box
The thermostat can work exclusively when paired with a specially prepared electric heating element, equipped with safety devices to limit excess
temperature and make the system safe in the event of abnormal factors (see Warnings).
1 - On/Off Button
st
1
pressing: Thermostat ON (Adjustment mode). The 1
nd
2
pressing: Thermostat Standby, all the led are switched off, heating is switched off. The2nd pressure will hear a sound long-term signal
2 - Two-color led (red/green) display:
a) Red led, heating status:
- Steady: Thermostat ON and heating is switched on
- Flashing: Thermostat ON and heating in manual mode (see radio control instructions)
b) Green led, operation modes:
- Steady: Thermostat ON and heating is not switched on
- Slow flashing: Economy operation by Pilot Wire or radio control (see radio control instructions).
- Normal flashing: Holiday operation by Pilot Wire or radio control (see radio control instructions).
- Alternating green/red flashing: Thermostat sensor not working.
c) Led off: Standby operation by Pilot Wire or radio control
3 – Orange led, Radio Reception:
- Normal flashing: reception of RF command (reception of Operating mode and other settings).
- Slow flashing: thermostat to radio control pairing mode
- Fast flashing: no connection. In this case the thermostat will adjust the temperature according to the last setting received from the radio
control until a new setting is received. (Check whether the problem is caused by the batteries of the radio control or by the radio control being too far from
the thermostat, see radio control instructions.)
Paring mode (registration of the radio control code in the thermostat).
In order to pair the RF thermostat with the remote control, select Adjustment mode and then press the On/Off Button for 10 seconds until the Orange led
begins flashing slowly. The thermostat is waiting for connection with the radio control. For more information, see the radio control instructions. Once
pairing has been completed, the thermostat shifts to Adjustment mode.
When restarted after a power failure during operation, the thermostat Orange led will begin flashing fast to indicate the absence of transmission with the
radio control. Operation will be resumed automatically after a few minutes or can be instantly resumed by using the radio control to adjust the
temperature setting or Operation mode as required (see radio control instructions).
in accordance with article 14 of the Directive 2012/19/EU of 07/07/2012 on waste electrical and electronic equipment.
•
The symbol shown above, present also on the equipment, indicates that it has been placed on the market and that, when the user decides to get rid of it, it must be disposed of in
separate waste collection (including all the components, sub-assemblies and consumer materials which are an integral part of the product).
•
For information on the systems for collecting these appliances, please contact the company IRSAP SPA or another subject enrolled in the various National Registers for other
countries in the European Union. Waste produced in the home (or of similar origin) may be consigned to systems for the separate collection of urban waste.
•
When buying a new appliance of an equivalent type, it is possible to hand over the old equipment to the seller. The seller will then contact the subject in charge of the collection of
the equipment.
•
The appropriate separate collection of the scrapped equipment and the subsequent operations of processing, recovery and environment-compatible disposal, allows the avoidance
of potential negative effects on the environment and on human health, while favouring the recycling and recovery of the component materials.
•
The unauthorised disposal of the product by the user entails the application of the sanctions contemplated under the national approval of Directives 2011/65/EU, 2008/98/EC and
2015/1127/EU.
All manuals and user guides at all-guides.com
DIRECTIONS FOR USE
METHOD OF USE AND OPERATION
st
time the button is pressed, a double audible signal is emitted.
INFORMATION FOR USERS
