Idiomas disponibles
Idiomas disponibles
Press any button and shows in red color: it
means that the current selection is to control
camera 1;
Press any button and shows in green color: it
means that the current selection is to control
camera 2;
Press any button and shows in blue color: it
means that the current selection is to control
camera 3;
Press the key to select the camera to be
controlled;
Manual focus, only valid under manual focus
model;
Control the lens zoom rate;
In normal working mode, use navigate key to
control pan/tilt;
In normal working mode, short press to let the
camera go back to Home position;
All manuals and user guides at all-guides.com
In normal working mode, press to enter the
menu, and then press to close the menu;
Set Preset: Long press(3seconds) the number
button to save preset;
Run Preset: Short press the number button to
run the relative preset;
In normal working mode, after a short press,
the selected camera will enter the standby
mode, and then press the camera again for
self-test and return to home position.
Press and hold for 3S to reset the camera
parameters to the factory settings;
As shown in the figure on the right, when
setting the parameters such as IP address in
the menu, you can input the number of IP
address with the multiplexed number key. In
the non menu mode, these keys are used as
the functions identified on the keys, and can
be used to set IP and other parameters after
entering the menu.
