Idiomas disponibles
Idiomas disponibles
BATTERY LIFE (VALUE FOR GUIDANCE PURPOSES)
Manoeuvre duration (s)
5
15 months
10
8 months
15
5 months
20
4 months
25
3 months
30
2 months
USE OF THE RECEIVER-PANEL
This receiver-panel is designed for use as a remote control for automatic doors.
Its use is not guaranteed for directly activating any other equipment different to that specified.
The manufacturer reserves the right to modify equipment specifications without prior notice.
IMPORTANT SAFETY INSTRUCTIONS FOR INSTALLATION
· Disconnect the power supply before handing the equipment.
· Before installing the panel, remove all unnecessary ropes or chains and disable any equipment such as locks that is not necessary
for the automatic operation.
· Before installing the panel, check that the door is in good mechanical condition, correctly balanced and that it opens and closes
correctly.
· Install the manual unlocking device at a height lower than 1.8m.
· Install any permanent control next to the door away from any moving part and at a minimum height of 1.5m.
· An easily accessible disconnection device must be fitted to the wiring for permanently connected equipment. It is wise for this to be
an emergency switch.
· Check that there is a security measure that protects the engine when reach the final point (open and closed).
· Check that you can not activate the door without seeing it.
· Check that the semi-automatic mode works in the open way (and not in the close way).
· This equipment can only be handled by a specialist fitter, by maintenance staff or by a suitably trained operator.
· To connect the power supply and motor wiring, 3.8 mm2 section terminals must be used.
· Use protective goggles when handling the equipment.
· Fuses must only be handled when the appliance is disconnected from the mains.
· The instructions for using this equipment must remain in the possession of the user.
· European door normative EN 12453 and EN 12445 specify the following minimum protection and door safety levels:
for equipment for residential, commercial and light industry use, prevent the door from being able to come into contact with any
object or limit the contact force (e.g. safety edge).
IMPORTANT SAFETY INSTRUCTIONS FOR USE
· Do not allow children to play with the door controls.
· Keep the remote controls out of the reach of children.
· Watch the door movement and keep people away until the door is fully open or closed.
· Precaution when operating the manual unlocking device, as the door may suddenly fall due to the bad condition of the springs or
door unbalance. Details on how to use the manual unlocking device must be provided by the manufacturer or the device installer.
· Examine the installation frequently, especially the cables, springs and supports, to detect signs of wear, damage or unbalance. Do
not use the door if repair work or adjustments are required, as this may cause damage.
EU DECLARATION OF CONFORMITY
JCM TECHNOLOGIES, SA hereby declares that the products ROLL868 DMR, ROLL868 DMR-P comply with the relevant
fundamental requirements of the RED Directive 2014/53/EU, as well as with the Machine Directive 2006/42/EC whenever its usage
is foreseen; and with the 2011/65/EU RoHS Directive.
See website www.jcm-tech.com/en/declarations
JCM TECHNOLOGIES, SA · C/ COSTA D'EN PARATGE, 6 - 08500 VIC (BARCELONA) SPAIN
ROLL868 DMR / ROLL868 DMR-P
20
16
18 months
24 months
9 months
12 months
6 months
8 months
5 months
6 months
4 months
5 months
3 months
4 months
Disconnect the power supply whenever you proceed
to the installation or repair of the control panel.
Manoeuvres / day
12
8
36 months
72 months
18 months
36 months
12 months
24 months
9 months
18 months
7 months
15 months
6 months
12 months
4
2
144 months
72 months
48 months
36 months
29 months
24 months
9
