Idiomas disponibles
Idiomas disponibles
DESCRIPTION
HINTS BEFORE FIRST USE
•
Some parts of the iron have been slightly greased and as a result the iron might smoke slightly when
switched 'ON' for the first time. After a short while, this will cease.
•
Before using for the first time remove any sticker or protective foil from the soleplate with a soft cloth.
•
Keep the soleplate smooth: do not scratch against metal objects (e.g. rack of ironing board, buttons,
zippers)
•
Pure woolen fabrics (100% wool) may be pressed with the iron set to a steam position. Preferably
select steam selector position and use a dry pressing cloth.
SETTING THE TEMPERATURE
•
Always check first to see whether ironing instructions are attached to the article to be ironed (they
can be found on a label showing a drawing of an iron. The numbers of dots indicate the correct
temperature. Refer to the indications on the temperature dial and in the table below). Follow these
ironing instructions in all cases.
•
If ironing instructions are missing but you do know the kind of fabric, then see the below. The table is
valid for the actual materials and do not concern any applied finish, gloss etc.
•
Textile to which some kind of finish has been applied (gloss, wrinkle relief etc.) can best be ironed on
somewhat lower temperatures.
•
Sort the fabrics out according to ironing temperature first: wool with wool, cotton with cotton, etc. The
iron heats up quicker than it cool downs. Therefore, start ironing the articles requiring the lowest
temperature such as those made of synthetic fibers. Then progress to higher ones.
•
Turn the temperature control knob round until it is opposite the setting pointer.
P-4
Textile
MIN
Synthetics
。
Silk
。。
Wool
。。。
Cotton
MAX
linen
HOW TO FILL WITH WATER
•
Remove the plug from the
socket
•
Fill the water through the filling opening into the water tank.
•
If the water is very hard, it is advised to use distilled water or demineralized water only. Do not use
chemically descaled water.
•
Pour out the remaining water after use.
SURGE STEAM IRONING
•
The surge-of-steam feature provides powerful steam for removing stubborn wrinkles.
•
Fill the iron with water as described in "How to fill with water".
•
Plug iron into electrical outlet.
•
As indicated on the temperature control knob, steam ironing is only possible at higher temperature
setting indicated with 'MAX' mark, otherwise the water will leak from the soleplate.
•
Turn the temperature control knob to the position according to the fabric being ironed as described in
point 4 of 'Setting the temperature'
•
The indicator light will turn 'OFF' when the indicated setting reaches the correct temperature.
•
Press the Steam jet button to release the surge-of-steam. Pressing the button several times may be
necessary to prime the surge system..
•
Wait a few seconds for the steam to penetrate the fabric before pressing the button again for more
steam.
•
NOTE: For optimum steam quality, do not apply more than four successive 'SHOT' after the indicator
light goes off.
CLEAN & MAINTENANCE
•
Please unplug the iron and allow to cool the heating plate when carry out the maintenance.
•
Warning: To protect against electric shock, do not immerse cord, plug, or appliance in water or any
other liquid.
Temperature
Instruction
control
on label
Low
Always Refer
temperature
Normal
Always Refer
temperature
Normal
Always Refer
temperature
Normal& high
Always Refer
temperature
High
Always Refer
temperature
P-5
