Idiomas disponibles
Idiomas disponibles
HOW TO CHARGE THE BATTERY
PACK
WARNING:
This Lithium-Ion battery pack is shipped partially
charged. Fully charge the battery pack before
using it for the first time.
NOTE:
Charging batteries at a ambient temperature of 32°F(0°C)-
104°F(40°C).
1. Charge the Lithium-Ion battery pack only with the
correct charger.
2. Connect the charger to a power supply, the light
indicator of the charger turns red.
3. Align the raised ribs of the battery pack with the slot in
the charger.
4. Insert the battery pack into the charger, the light
indicator of the charger turns green and it flashes.
5. The charger will communicate with the battery pack to
evaluate the condition of the battery pack (Fig.7).
6. It is fully charged that the four lights of the battery turn
on. Disconnect the power supply from the charger.
Remove battery pack from the charger.
CHARGING INDICATOR
Press the light button (Fig.8) to check the battery pack
whether needs to charge.
Lights
Lighted
Off
Blinking
EN - 18
Status
The battery is at full
capacity.
The battery is at 75%
capacity.
The battery is at 50%
capacity and requires
charging.
The battery is at 25%
capacity and requires
charging soon.
WARNING:
Malfunctions may occur when the four lights
blinking in turns.
OVERHEAT PROTECTION
When the tool/battery is overheated, the tool stops
automatically. In this situation, let the power tool/battery cool
before turning the tool on again.
OVERDISCHARGE PROTECTION
When the battery capacity is not enough, the tool stops
automatically. In this case, remove the battery from the tool
and charge the battery.
MAINTENANCE
WARNING:
Always switch the product off, remove the
battery pack and let the product cool down
before performing cleaning and maintenance
work!
Always wear eye, hearing, hand, foot and body
protection to reduce the risk of injury when
operating this unit.
Only perform cleaning and maintenance work
according to these instructions! All further works
must be performed by a qualified specialist!
And only use specified spare parts for
replacement.
LUBRICATING THE BLADE
WARNING:
Always allow the blades of the hedge trimmer to
come to a complete stop and pull out the battery
pack before lubricating. Failure to do so could
result in accidental starting causing possible
serious personal injury.
The battery is less
than 5% capacity and
requires charging
immediately.
WWW.SENIXTOOLS.COM
