10. CRADLE MOUNTING INSTRUCTIONS
10.1 Cradle Mount Unistrut Installation (Recommended)
Suitable for Unistrut up to 1 5/8" (41.28 mm) wide and 1 5/8" (41.28 mm) tall.
1
Place the power supply on a flat work surface as shown, with the
"FLUENCE" name upside down. Place one bracket behind the power
supply end plate and align the screw holes.
2
Install a screw and washer in each hole and tighten. Ensure the washer
is installed in the correct direction as shown for proper fit and function.
Do not overtighten.
3
Repeat steps 1 and 2 at the opposite end.
4
Turn the power supply over. Lift it over the top of the unistrut, and
lower it onto the unistrut. Rest it on the unistrut securely in the
bracket slots.
5
Take (2) wire form clips and install them as shown on the brackets
across the bottom of the unistrut. Install the clips downward for 1 5/8"
(41.28 mm) tall unistrut, or upward for 13/16" (20.37 mm) tall unistrut.
6
Hold a VYPR 3x fixture up to one side of the brackets, and slide it onto
the brackets. Align the fixture evenly and guide the brackets between
and through the cooling fins. Rest the VYPR 3x fixture on the brackets.
Ensure that the brackets are all the way through, and the VYPR fixture
top frame rests securely on the brackets as shown.
7
Repeat Step 6 to install the second VYPR 3x fixture on the
opposite side.
5c
18
6a
1
3
5a
6b
2
4
5b
7
