Getting Started; Status Lights - Conservator NTW3811 Manual Del Propietario E Instrucciones De Instalación

Getting started

To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY
WARNING
INSTRUCTIONS before operating this appliance .
Throughout this manual, features and appearance may vary from your model .
Step 1
• Add fabric softener to the
fabric softener dispenser;
see page 10.
• If using detergent packets,
add to the bottom of the
wash basket before adding
clothes. We recommend
the use of High Efficiency
laundry packs.
Start/Pause
A
Press Start to begin the cycle . NOTE: If the lid is closed, the lid will lock only during the load sensing portion of the cycle (when
the Auto selection is made or models which do not have a load size selection) and during spin portions of the cycle . Lid will unlock
after load sensing and spin .
NOTE: The lid must be closed for the washer to start cycle .
Pressing Pause will unlock the lid (if locked at that time), pause the cycle and the Start indicator light will blink .
To continue the cycle, press Start again . If water remains in the machine, select the Drain & Spin cycle to drain basket and
spin water out of the washer basket . NOTE: Machine will automatically cancel and drain when water is present and the lid is
left open for 15 minutes or the unit is left in a paused state for 24 hours with the lid closed . Select cycle and press Start to
begin new cycle .

Status Lights

B
Cycle status lights: Shows whether the washer is in the Fill, Soak, Wash, Rinse or Spin portion of the cycle .
If an out-of-balance condition is detected by the washer, the Spin light will blink during the remaining portion of the cycle
and will stay illuminated for a short time after cycle completion . When this occurs, the washer is taking actions to correct the
out-of-balance condition and complete the cycle normally . In some cases, the washer may not be able to balance the load
and spin up to full speed . If you notice the load is more wet than normal at the end of the cycle, redistribute the load evenly
in the wash basket and run a Drain & Spin cycle .
Feature status lights indicate (see section E):
Pause - Will turn on when washer is paused between cycles .
Lid Locked - The lid is locked .
49-3000336 Rev 0
C F
Deep Rinse
Select when adding Fabric Softener
Perm. Press
Load Size
Warm Wash
Heavy
Medium Large
Small Auto
Light
Whites
Hot Wash
Heavy
Step 2
• Loosely add items around
agitator or Infusor. Overloading
may negatively impact wash
performance. See page 11 for
suggested loading examples.
• Add the manufacturer's
recommended amount of detergent
to the top of the load after adding
clothes. We recommend the use of
High Efficiency laundry packs.
B A
Fill Soak Wash Rinse Spin
Pause
Lid Locked
Start / Pause
Hold 3s to Cancel
Light
Delicate
Cool Wash
Cool
Colors
Normal Wash
Tap Cold
Drain & Spin
D
Step 3
• Close lid.
NOTE: Unit will not start
with lid open if Auto is
selected except on Bulky
Items/Bulky cycle.
• Select wash cycle.
• Select wash options, including Deep Rinse
when using fabric softener.
• Select options.
• Select load size.
Step 4
• Press
Start.
5