Idiomas disponibles
Idiomas disponibles
AIR 80
3. Oscillation button: press "OSC" button, the air direction oscillates horizontally. Pressing it again stops this
function.
You can also rotate the blades crosswise manually, choose the air stream up and down.
4. Humidification button: press the "COOL" button to make it start to work. If you add the cold packs, the
temperature of the air outlet vent can drop up to 3ºC below the ambient temperature after a few minutes. If
you press the button again, this function stops.
5. Timer: You can set a sleep time between 30 minutes and 7.5 hours.
6. To turn off the air conditioner, press the "POWER" button.
7. All functions can be realized by remote control
REMOTE CONTROL
The remote control allows you to control the same functions as the control panel. Always point the remote
control towards the front of the air conditioner when you want to use it.
Do not mix different types of batteries or new and old.
Remove the batteries from the remote control if it is not going to be used for long periods of time.
Works with two 1.5V AAA batteries (not included)
THE USE OF ICE BOX
The ice crystal has the main characteristic of keeping cold, it can absorb the heat of the water and make the
water temperature in the tank drop below room temperature, so that the air will be much colder.
How to use:
a. Add water to the TANK to the MAX indication and place it in the freezer to make sure it freezes
completely.
b. Place the ACCUMULATOR on top of the air conditioner
c. There are two ACCUMULATORS that can be used interchangeably.
CLEANING AND MANTENANCE
1. Clean the air filter screen
Disconnect the plug, remove the two screws from each of the three air filter screens and remove them from
the air conditioner. Clean the air filter screen with neutral detergent and a brush. Then clean it with clean
water and re-install it on the device.
2. Clean the wetted pad
Disconnect the power plug, remove the air filter screen and remove the wet pad from the holder. Clean the
damp pad with neutral detergent and a brush. Then clean it with clean water and reinstall it on the device.
Attention: The wet pad must be installed completely, in order to avoid leakage.
3. Clean the water tank
Disconnect the plug, open the two latches located on both sides of the cooler, remove the upper part of the
cooler and place it on a cloth or paper to absorb any drops of water that may remain in the water pump.
Wash it with neutral detergent and rinse with water. Once dry, reassemble the air conditioner.
11
