VELTIUM LITE Zero Guía De Usuario página 26

USER GUIDE - VELTIUM LITE
Charge information
q Start : shows the time when the vehicle was connected to the charger.
q Charge : shows the accumulated consumption of the charge in progress, measured in kWh.
Charge control dial
q The number in the centre of the dial indicates the power/intensity at which the vehicle is
charging in real time. By pressing this number the magnitude and scale of the dial will appear
alternatively in kW or A.
q The dark green strip at the bottom of the dial indicates the range of power/intensity to which
you can turn the charge selector. This range will be:
Minimum: the minimum power/intensity admitted by electric vehicles (6 A).
•
Maximum: the minimum power/intensity between that of the installation and the active
•
schedule at any given time, depending on how these parameters are configured in the
charger settings and schedule.
The blue pointer on the dark green strip is the charge selector that allows you to select the •
power/intensity of the maximum value at which the vehicle can be charged.
Charge control dial (with Dynamic Power Control)
If the Dynamic Power Control (CURVE or METER) is enabled in the settings, the charge control dial
will have the following modifications:
q Under the rate you will see the letters DPC (Dynamic Power Control).
q In the dark green strip on the outside of the dial the power/intensity range will be:
Minimum: the minimum power/intensity admitted by electric vehicles (6 A).
•
Maximum: the minimum power/intensity between that of the installation and the
•
contracted/available power, depending on how said parameters are configured in the
charger settings.
q The charge selector disappears given that it is the charger itself that establishes the maximum
power/intensity at which the vehicle can be charged according to your home consumption at
any given time.
Action buttons
In this area the following buttons may be available:
Unlock
Charge now
Stop
This button will be accessible when the charger is locked and the Lock Control
is in MANUAL mode in the charger settings. If the vehicle is connected at this point, the charger status will change from AVAILABLE to CONNECTED or
CHARGING.
This button will be accessible when the charger is in the CONNECTED status
and an active schedule exists, but the charging time has not yet started.
This button will be accessible when the charger is in the CHARGING status.
Once the charge has stopped, the charger will remain in the CONNECTED
status until the vehicle is disconnected.
EN
26