INSTALLATION (continued): Prior to installation, connect wires as shown in wiring diagram.
TRUNION MOUNTING (Suitable for all models.)
STEP 1: Remove existing mounting provided with the
fixture by removing the securing bolts at the bottom of
the fixture housing. Attach Trunnion mount to the fixture
reusing the securing bolts.
STEP 2: Secure the fixture to wall as shown in Figure 4,
using the appropriate anchors (not included).
STEP 3: Loosen the pivot bolts and angle locking
screw.
STEP 4: Adjust fixture to desired angle.
STEP 5: Tighten pivot bolts and angle locking screw.
SLIPFITTER MOUNTING (Suitable for 60W, 80W,
100W, 150W.)
STEP 1: Place the slipfitter over the tenon and secure
the fixture with the screws on the side of the slipfitter
as shown in Figure 5.
STEP 2: Loosen the locking bolt and swivel fixture to
desired angle as shown in Figure 6.
STEP 3: Tighten the locking bolt.
IMPORTANT: The installation height must be
greater than 4 feet.
Figure 4
Angle locking scew
Pivot bolts
Photocell, CCT and Wattage Adjustments
• Use a screwdriver or coin to unscrew the protective
plugs. See Figure 8 for all possible adjustments.
• Photocell Adjustment: User may select "ON" to turn
photocell on, or "OFF" to turn photocell off.
• CCT Adjustment: User may select desired color
temperature to 3000K, 4000K or 5000K.
• Wattage Adjustment: User may select desired output
wattage by sliding the switch to High, Medium or Low.
• After adjustment is finished, screw the protective plug
back and tighten it.
Figure 5
Fixture
Slipfitter mount
2
WIRING DIAGRAM
Figure 6
Fixture
Slipfitter mount
Figure 8
Photocell Adjustment
Locking bolt
Wattage and CCT
Adjustment