Idiomas disponibles
Idiomas disponibles
continuously and allow to completely cool down for at
least 5 minutes.
- Power off the device while changing attachment.
- Clean and lubricate the clipper regularly to ensure
better performance and longer life.
- Never leave unattended while it is running.
- Do not wrap the power cord around the unit during use.
Pay attention to the power supply. An incorrect
voltage may damage the motor and jeopardize the
functionality of the device.
DESCRIPTION G30049
1. Blade
3. Display
5. Charge level
6. Charging input
9. Small brush
10. Lubricating oil
OPERATING
The hair clipper can be used both weather it is connected with the USB cable or not.
WARNING: if during battery working the appliance stop working, put switch (4) in OFF position, connect
USB cable (8) to a proper USB charger and to connector (6). Wait one minute before starting again operation.
HOW TO USE
- Keeping off the unit, mount one of the supplied combs (7). Choose the attachment depending on the length
you wish to obtaine (3, 6, 9, 12 mm).
- If you want to obtain a shorter cut, between 0.8mm and 2mm, use the clipper without any comb (7). If so,
set the cutting height using the regulator (3).
- Turn on the clipper by setting one of the 2 speeds with the ON/OFF button (4) and start cutting.
- Once finished cutting operation, turn off the device using the power button (4), remove any comb and store
the clipper and its accessories out of the reach of children.
RECHARGING
When you first use the product fully charge it, leaving it connected for at least 2.5 hours.
To recharge, connect the USB cable (8) to a suitable USB socket (PC, USB charger, power bank....) and into
the connector on the rear of product (6). During charging, the charge indicator (5) indicates the current level,
and the battery symbol flashes. At the end, the level is 100 and the battery symbol remains on steady.
The following measures will preserve the battery life.
At first use the product fully charge the product, leaving it connected for at least 2.5 hours. Before you
recharge, completely discharge the battery.
When the unit is not in use for a long period (2 months), it is recommended to let it charge for about 2.5 hours
before using. In any case it is advisable to fully discharged the battery before recharging. If the appliance,
even after a recharge, works only if it is connected to the cable, it is possible that the battery is no longer
capable of delivering enough power to the unit. In this case, please contact an authorized service center.
MAINTENANCE AND CLEANING
After each cut, always clean used comb (7) and cutting blade (1) by blowing over them or using the small
brush (9). Periodically lubricate the blade by following the steps below. Open the blade set (11), pushing the
blade as shown in figure below. Remove remaining hair by blowing or using the small brush (9).
3. Cutting regulator
7. 4 combs set
11. Removable blade set
4. On/off button
8. USB cable
10
