Idiomas disponibles
Idiomas disponibles
WF 0146 – WF 0147
Propeller Placement (4)
- Insert the propeller onto the motor shaft, fitting the motor shaft pin (6) into the slot on the back of the
propeller.
- Tighten the propeller fixing nut counterclockwise.
Front grill placement (1)
- Insert the edge of the front grill (1) into the other slot of the joint ring (2) so that both grilles are well
joined.
- Finally, tighten the screw of the union ring.
INDICATIONS
- This fan can be tilted up and down by manually moving the head to the desired position.
- To start the fan pull the right rope, with each pull it changes to a higher speed 0 – 1 – 2 – 3 - 0
- To select the oscillation mode of the fan, pull the left rope, pull it again to stop this function.
SOLUTION TO SIMPLE FAILURE.
- Always check if the plug is properly inserted in the socket.
- Always check if the propeller is touching any other part such as the protective grills (1, 5).
- If the fan produces noise or vibrations, check the following:
• Whether the propeller has been properly mounted on the shaft (6) of the motor.
• The rear grill (5) is firmly attached to the motor.
• The protective grill has become loose and rubs against the rotating propeller.
CARE, CLEANING & STORAGE
• Blades and grates should be cleaned regularly for best performance. Unplug fan and reverse assembly
instructions to remove blades and louvers before cleaning. Wipe clean with a damp cloth and dry with a dry
towel.
• Never immerse any part in water. Just wipe the fan with a damp cloth, then dry it immediately with a dry
towel.
• Always store your fan in a cool, dry place.
10
