Inserting/Replacing The Batteries - Novellini 40465ELE-30 Manual De Uso Y Mantenimiento

ENGLISH
Description of remote control:
mod. 40465ELE-30

Inserting/replacing the batteries:

Before inserting the batteries, make sure the power unit is powered up.
The remote control takes ALKALINE AAA LR03 1.5V batteries (supplied). When flat, they
must be replaced with two new batteries of the same type.
Insert the batteries respecting the polarity.
Before closing the door, make sure the water gasket is in place.
Description of remote control:
After inserting the batteries, the remote control searches for the sauna with which it
must dialogue.
Power to the sauna must therefore be on.
When this operation has been completed successfully (soon after inserting the
batteries), the remote control emits a beep.
Your remote control is now ready for use.
To optimise the life of the batteries, the display goes off 20 seconds after the last
command. To turn it on again, lightly press any point of the display.
Turning on:
Hold the display down until the introduction appears.
Main commands:
1- SAUNA
2- RADIO
1
3- CROMOLIGHT
5- ALL ACTIVE
FUNCTIONS OFF
6- ALARM
5
Menu Sauna:
Appuyer sur 1 pour accéder au menu de programmation du sauna.
NO OK
12:33
2
3
6
Adjusting the length of the sauna:
If the length and temperature are the same as the previoussauna, press button 5 to
confirm and start the sauna cycle.
7
To set the length of the sauna, press the 7 symbol in the same menu.
The length of sauna sub-menu appears.
Use the + and - buttons to vary the length of the sauna.
After setting the required length of time, press 10 to confirm.
Press 9 to start the sauna.
The time remaining is displayed and button 1 is marked to show that the sauna is on.
The countdown of the time left starts to decrease 8/11 minutes after the start of the
sauna to warm the cubicle before you enter.
NOTE: If the length of the sauna is set to 0, it will operate for about an hour starting
from the last command given.
1
Adjusting the climate:
Enter the sauna settings menu.
7
Press button 8 to enter the climate settings menu.
Use the + and - buttons to increase and decrease the temperature.
Press button A to return to the main menu.
-34-
12:33
12:33
3
2 8
1
10'
9
12:33
10'
10
10' 12:33
12:33
3
2 8
1
10'
9