Idiomas disponibles
Idiomas disponibles
Long tip enables application of the agent in difficult to reach places.
The amount of released fluid can be adjusted with the nozzle on the
tip and, if necessary, lock it in a given setting with the nut behind it.
NOTE: use the spray gun only with the liquids that will not damage
inside of the container.
3.4.
Cleaning and maintenance
a)
The varnish spray gun and spray gun should be cleaned after each use, if they
are not going to be used again. The varnish spray gun should be disassembled
and its elements thoroughly rinsed, e.g. in a nitro solvent. Depending on the
material used, the spray gun can be rinsed with extraction naphtha in most
cases. In both cases, blow out the elements with compressed air after cleaning.
b)
Use only non-corrosive agents for cleaning the surface.
c)
After each cleaning, all components should be well dried before the device is
used again.
d)
Store the device in a dry and cool place protected from moisture and direct
sunlight.
e)
Use a soft cloth and a brush for cleaning.
f)
Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or metal
scraper) as these may damage the surface of the device.
DISPOSAL OF USED DEVICES
At the end of its service life, this product must not be disposed of with normal
household waste, but should be taken to a collection point for the recycling of
electrical and electronic devices. This is shown by the symbol placed on the
product, operating manual or the packaging. The materials used in the device can
be reused according to their intended use. By reusing materials or conducting
other forms of using used devices, you make a significant contribution to the
protection of our environment.
Local administration will provide you with information about the
appropriate point for disposal of used devices
.
