Data Logger; Saving Data To Memory; Recalling Data From Memory; Memory Clear Function - Sonel DIT-500 Manual De Uso

6.3

Data logger

6.3.1

Saving data to memory

Your thermometer is capable of storing up to 100 measure-
ments.
To store data from an infrared reading, pull the trigger. While
holding the trigger, press the MODE button until LOG appears in
the lower left corner of the display (a log location number will be
shown in upper display).
Aim the unit at the target area you want to record and press the
LASER/BACKLIGHT button. The recorded temperature will appear
in the lower display. To select another log location, press the UP or
DOWN keys.
If no temperature has been recorded in the shown LOG loca-
tion, four dashes will appear in the lower display.
6.3.2

Recalling data from memory

To recall stored data after the unit shuts off, press the MODE
button until blinking MAX appears on the LCD. Press the UP or
DOWN button to call blinking LOG symbol on LCD. Press trigger to
accept.
A LOG location number will be shown on upper display and the
stored temperature for that location will be display on lower display.
To move to another LOG location, press the UP or DOWN keys.
6.3.3

Memory clear function

This function can only be used when the unit is in LOG mode.
You should only use the LOG clear function if you want to clear all
the Log location data that is stored in unit's memory. The "LOG
clear" function works as follows:

while in LOG mode, press and hold the trigger, and then press
the DOWN arrow button until you reach LOG location "000".
Note: This can only be done when the trigger is pulled. LOG loca-
tion "000" cannot be accessed, by using the UP arrow button.

when LOG location "000" shows in the display, press the
LASER/BACKLIGHT button. A tones will sound, and the LOG
DIT-500 – USER MANUAL
39