Idiomas disponibles
Idiomas disponibles
Note: Never use a powder descaler.
2. Fill the water tank up to the Max level with prepared solution.
3. Operate the appliance until the water tank is empty as if you brewed coffee, but
without paper filter and ground coffee in the filter holder.
4. Repeat steps 1 to 3 for another descaling cycle.
Note: Never refill the water tank with the used descaling solution because it is no
longer active.
5. Operate two more brewing cycles with fresh, cold water to remove all descaler
solution residues.
Important:
1) Never interrupt the descaling process.
2) Malfunctions caused by scale deposited inside the appliance are not covered
by the guarantee if the descaling process is not carried out properly.
Troubleshooting
If you have a problem, you may find the solution in the table below. In case these
solutions can not solve your problem yet, please contact with the nearest authorized
service agent for examination, repair or adjustment.
PROBLEM
The appliance does not
work.
Water leaks out of the
appliance.
The appliance produces
a lot of noise and steam
during brewing.
Coffee grounds enter
into the jug.
Brewing coffee takes
longer than usual.
10
SOLUTION
- Make sure the voltage indicated on the appliance
corresponds to the local mains voltage.
- Make sure the appliance has been plugged in &
switched on.
- Check if the water tank is filled beyond the MAX level.
- Make sure the water tank is not filled with hot water.
- The appliance needs to be descaled (see chapter
'Descaling').
- Check if the filter holder has overflowed because there
is too much ground coffee in the filter, or the jug has
not been placed correctly under the filter holder, or
you . remove the jug for more than 30 seconds during
brewing.
- Check if the filter is torn or you use the wrong size of
paper filter.
- The appliance needs to be descaled (see chapter
'Descaling').
INGLÉS
