Idiomas disponibles
Idiomas disponibles
Mounting Device on VESA Standard Mounting Plate
1. Start two (2) M4 screws by hand into the upper threaded
holes in the rear of the device or mounting adapter.
2. Lift the device by guiding the M4 screws into the slots in the
Mounting Plate.
3. Insert two (2) remaining M4 screws through the lower holes
of Mounting Plate.
4. Tighten all fasteners.
Making Adjustments to the Arm
Tilt & Tilt Tension
1. Loosen the Adjustment Lever (if included).
2. Grasp top and bottom of device and tilt it to desired angle.
3. Tighten the Adjustment Lever (if included).
4. Using a 5/32'' hex wrench, equally tighten or loosen the two
(2) Tilt Tension Screws.
Warning: Tilt tension screws must be torqued to a
minimum of 35 in-lbs [4.0 N-m].
Swivel & Swivel Tension
1. In most configurations, the mounted device will swivel at the
end of the Arm. To rotate the device simply push or pull the
corners of the device.
2. To adjust the swivel tension, tighten or loosen the Swivel
Tension Nut with a 1/2 [13 mm] socket wrench.
Warning: Swivel tension nut must be torqued to a
minimum of 20 in-lbs [2.3 N-m].
Pivot & Pivot Tension
Pivot Arm/Flush Mount – Single Pivot Point
1. To pivot at the Slide, simply push on the side of the Arm or
mounted device.
2. To adjust the pivot tension at the Slide, tighten or loosen the
Pivot Tension Bolt with a 1/2" [13 mm] socket wrench.
Articulating Arm – Dual Pivot Points
1. To pivot the Arm at the Slide, simply push on the side of
the Arm or mounted device.
2. To pivot the Arm at the midway pivot point, simply push on
the side of the front Arm or mounted device while holding
the rear arm in place.
3. To adjust the pivot tension at the Slide, tighten or loosen
the Pivot Tension Bolt with a 1/2" [13 mm] socket wrench.
4. To adjust the pivot tension, tighten or loosen the Pivot
Tension Bolt with a 1/2" [13 mm] socket wrench.
VESA Standard Mounting Plate
Swivel Tension Nut
Swivel Tension Nut
Pivot Tension Bolt
(Mid Point)
DU-WMM-0001-I-20 Rev A 1/09/09 GCX Corp. Page 2 of 3
M4 Screws (2)
VESA Mounting Plate
M4 Screws (2)
Tilt Tension Screws (2)
Single Pivot Point
Pivot Tension Bolt
Dual Pivot Points
Bolt Cap
Pivot Tension Bolt
