Idiomas disponibles
Idiomas disponibles
Cleaning the Washable Filters
To maintain optimum cleaning performance regularly remove the filters and tap against the side
of the bin to release dust. The filters should be washed by hand in warm water when the filter has
reached an excessive dust level. Do not use hot water or detergents.
IMPORTANT: All bagless cleaners require regular filter cleaning. Failure to clean your filters may
result in air blockage, overheating and product failure. This may invalidate your guarantee.
*Certain models only
IMPORTANT: Always ensure the filters are fully dry before use. Do not use the product without
the filter fitted.
UV-C Lamp Cleaning
To remove the UV-C Lamp cover plate, remove the 2 screws [12] and remove the UV-C cover
plate. Use a dry soft cloth or cotton swab to gently wipe clean the lamp [12].
After cleaning replace the UV-C Lamp cover plate and secure the cover in place using the 2
screws.
IMPORTANT:
The penetrability of the UV-C lamp is weak, any paper, lead, glass or plastic may greatly reduce
the intensity of UV-C irradiation. Any dust or oil on the UV-C lamp will directly affect the
penetrability. The UV-C lamp should be cleaned regularly.
Do not touch the UV-C lamp with your bare finger, the stain you leave on it will affect the
penetration of sterilization light.
Regularly check and maintain the filters.
If the appliance will not be used for a long time, please store the appliance in a cool dry place, do
not store your appliance in damp conditions or in direct sunlight.
The following is a list of commonly encountered problems and solutions. If any of these problems persist
contact the representative.
The Mattress Cleaner
does not work
Reduced Suction
UV-C lamp does not
work
Is there a working
electricity supply to the
appliance?
Has the appliance been
switched on?
Is the appliance blocked?
Is the Pre-Motor Filter
Blocked?
The reflection of the object
surface is very poor or is
too far away from the
appliance.
Is the appliance being
used at an angle over 30
degrees?
Is the UV-C lamp
damaged?
Check the power supply with
another electrical product.
Switch on the Power Button.
Clean the suction inlet.
Clean up the bin and Pre-
motor filter.
Normally the UV-C lamp will
turn on automatically within
10cm of the cleaning surface.
Appliance must be used at
less than a 30 degrees angle
for the UV-C Lamp to operate.
Contact the after-sales service
to replace the UV-C lamp.
