Idiomas disponibles
Idiomas disponibles
EN
INTRODUCTION
Thank you for the purchase of our quality product. Used carefully and in accordance with the instructions
set out below. Please read and keep these instructions for future reference.
TECHNICAL CHARACTERISTICS
Power: 45W.
Decibels: 53.48dB
RPM: 900/1050/1250.
Air flow: 55.28m
/minute.
3
Coverage area: 20m
Adjustable tilt: 10°
Oscillating diffuser: 90°
Voltage: 220-240V~ 50Hz.
Remote control batteries: 2 AAA (Not included).
MOUNTING INSTRUCTIONS
BASE
1. Lay the two feet of the stand (Picture 1) across
each other, at right angles, and fit them to the
upright using the four screws (Picture 2).
2. Remote the height lock from the upright.
3. Slide the protective cover into the upright, and
fit it over the feet.
4. Fit the heigt lock to the upright.
5. Unscrew the locking ring (Picture 3) from the
motor housing (by turning it counterclockwise)
and remove the ring from the motor housing.
6. Fit the rear of the fan housing (Picture 3) onto
the motor housing, making sure that the ope-
nings are aligned precisely with the ligs on the
motor housing and that the grip is at the top.
Picture 1
FAN
1.Slide the locking ring (Picture 4) onto the shaft,
and screw it tight (clokwise).
2. Slide the fan blades (Picture 4) onto the shaft,
making sure thaht the notches are aligned with
the two keys on the shaft.
6 | www.garsaco.com
.
2
Picture 2
Picture 3
3. Fit the spinner onto the shaft (Picture 4) and
ltighten it (anticlockwise) whilst preventing the fan
blades from moving.
4. The rim has five clamps.Carefully fit the rim
around the rear half of the fan housing, making
sure that the housing falls into the upper clamp
of the rim, so that you can connect the two hafs
of the fan housing with the nut and bold. Use
a crosshead screwdriver to screw the bolt into
the nut.
5. Close the other clamps.
Picture 4
CÓMO UTILIZAR
FAN
1. Conect the plug into an electrical socket and
switch on at the wall.
2. You can control your wall fan either with the
remote controller or with control buttons on the
control panel.
3. Pressthe "ON/SPEED" button. At first start-up
the fan will operate al low speed.
4. Press the same button to chose betwen low,
medium, and high speed.
5. Press "OSC" button switch on the oscillation
mode.
TIMER MODE
The appllance can be turned of manually by
pressing the OFF button. However this appliance
is fitted will a timer with allows you to shut off
the appliance at the end of a pre determed time.
By pressing the TIMER button reapeatedly you
incrase the time in increments of 0.5 hours.
For example: If you want to shut off the appliance
after 3.5 hours, press the TIMER button repead-
tedly, till the indicato lamps 0.5h, 1h and 2h are lit
at the same time.
