Idiomas disponibles
Idiomas disponibles
Use and fit (figure F)
Brush excess hair back and out from beneath the cushions with your hand as much as possible. Be certain
that the cushions seal tightly against the head with no interference from objects such as respirator
headbands or spectacle frame, in order to obtain the best performance. With the headband over the
head, place the ear cups so as to completely enclose the ears. The ear cups may be adjusted up or down
the headband to adjust for a firm, comfortable fit. This safety requirement is satisfied for the sizes:
NECKBAND VERSION
Use and fit (figure G)
Brush excess hair back and out from beneath the cushions with your hand as much as possible. With the
neckband behind the head, place the ear cups so as to completely enclose the ears. Be certain that the
cushions seal tightly against the head with no interference from objects such as respirator headbands
or spectacle frame, in order to obtain the best performance. Adjust the net over the head so the hearing
protector don't fall off. Note! Do not pull the net to tight because it will affect the cushions seal, the
net shall only hold the hearing protector in place, not pull the hearing protector upwards. This safety
requirement is satisfied for the sizes:
Amplification
At the two highest volume stages the hearing protectors amplifies the ambient sound.
Battery warning
A tone will be heard when about 40 hours battery life remains. The battery warning will be heard after 10
seconds in connection with starting up the electronics and will be repeated every 30 min.
Connection
The product has one input, 3.5 mm, for connecting an external acoustic source, e.g.: communication
radio, hunting radio, mobile phone, etc. We recommend that you connect the angled jack plug to
the hearing protectors as this gives the most secure connection and is least interfering. Refer to the
operating instructions for the external audio equipment to ensure that it is correctly connected. The
circuit must not be subjected to a signal greater than 5 volts to prevent permanent damage.
Input signal level level for which the mean plus one standard deviation equals 82 dB(A): 225 mVrms.
Note! Please see Table 1 for more detailed information.
THE FOLLOWING SUPPLEMENTARY INFORMATION APPLIES ONLY TO VERSIONS 75302-X LED
LED LIGHT (figure H)
Your hearing protector is equipped with a LED light. To activate the LED light press the + and – buttons
at the same time, to inactivate the LED light press the + and – buttons at the same time. The LED light
automatically shut off after three minutes.
THE FOLLOWING SUPPLEMENTARY INFORMATION APPLIES ONLY TO VERSIONS 7*302-X and 7*302-
X LED (figure H)
Audio Profiles
Your hearing protector is equipped with four different audio profiles:
Hunting
• Main audio profile
• User situations: General hunting profile for various forms of hunting
When switched on, press the (O) button (figure D) to switch between Hunting and Shooting mode. You will
hear one short beep when entering Hunting mode.
Shooting
• Comfort profile with a lower gain and reduced frequency spectrum
• Adapted for face to face communication
• User situations: Shoot training and recreational shooting
When switched on, press the (O) key (figure D) to switch between Hunting and Shooting mode. You will
hear two short beeps when entering Shooting mode.
Focus
• Higher sound amplification and wider frequency spectrum. For higher situational awareness
• User situations: Low sound environment where high gain is requested
When switched on, set the volume to max and then press and hold the + button (figure D) until three short
high-pitch beeps are heard. The Focus profile is only available in Hunting profile.
S M L
25
M L
