Idiomas disponibles
Idiomas disponibles
C.
Paper Clearing:
When paper is jammed in the paper path of
MFPP-C1 the LCD display shows the area where
a sheet(s) is jammed.
Area
Area A
If paper is jammed in the Punch Bypass, lift the
handle until it latches with the locking mechanism.
Reach and remove the jammed paper.
To close the paper guide, press the upper latch
lever while holding the guide plate handle and
lower the guide plate to close it firmly.
Area B1
If paper is jammed in the downward paper chute,
move the chute to the right, reach in and remove
the jammed paper.
Ensure the paper chute is closed.
Area B2
If paper is jammed in the right bottom chute, press
the top lever while holding the bottom lever. This
will unlatch the chute; continue to open the chute
until it reached the magnet on the right side. Reach
in and remove the paper. To return the chute to
the closed position, move it back in the opposite
direction until the latch mechanism is activated.
Ensure the paper chute is closed.
Area B3
If paper is jammed in the left bottom chute, unlatch
the chute, reach in and remove any jammed paper.
Ensure the paper chute is closed.
Area B4
If paper is jammed in the upward paper chute,
move the door to the left, reach in and remove the
jammed paper.
Ensure the paper chute is closed.
Area B2/B3
Before uninstalling the die set, ensure Area
B2 and B3 are cleared of any jammed paper. If
there is jammed paper cannot be removed from
Area B2 and B3, uninstall the die set to remove
the jammed paper. (see Section 4. Changing the
Interchangable die sets)
Description
5. USER DISPLAY OPERATION CONTROLS
The MFPP-C1 has a touch screen interactive LCD panel that provides
messages, settings, and information relating to the functions of the
punch unit.
Settings
Punch, Crease
or Perforation die
inserted
Punch die inserted
Mode
Alignment
Backgage
Crease die inserted
Crease Mode
Center Crease
Book Crease
Select
Adjustment
Adjustment
Perforation die inserted
Perf Mode
Center Perf
Single Perf
Select
Adjustment
Adjustment
LCD Panel Overview
Messages on the LCD Panel
1.
Ready
MFPP-C1 is ready to run the selected mode.
2.
Running
MFPP-C1 is running in the selected mode operation.
3.
Chip tray Full
When the punch container becomes full of wastepaper chips, this
message will be displayed.
4.
Chip tray Out
When the punch container is removed or not fully inserted into the
punch unit, this message will be displayed.
5.
Check die
When the Die Set is removed or not fully inserted into the punch unit,
this message will be displayed. When this message is displayed the
punch unit will run in Bypass mode only.
6.
Close Door
When the Front door is open or not completely closed this message
will be displayed.
7.
Paper jam
When a sheet of paper becomes jammed within the punch unit, this
message is displayed. See the section of this manual titled PAPER
CLEARING for instructions on how to remove a jammed sheet.
MFPP-C1
Home
Info
Clear Cover
Language & Units
C-Fold Crease
Language & Units
Adjustment
Double Perf
Language & Units
Adjustment
GB
7
