Idiomas disponibles
Idiomas disponibles
Place the bottle in its compartment, being careful that the tube is not twisted and
does not have hot parts.
To replace the bottle, make sure that the tap is turned off and that there are no
open flames (oven on, etc.) or heat sources in the place where you are working.
Check the gas hose once a month and every time you change the bottle if it
shows cracks, partitions or other deterioration, it should be replaced with a new
one. In any case it is advisable to replace the hose every two years.
Do not tamper with connections or other components.
Do not turn the bottle upside down to fully use its contents: this releases liquid
residue into the tank that will irremediably damage the appliance.
5.
USING YOUR APPLIANCE
WARNING: ALWAYS ACCESS THE CONTROLS AND THE VALVE FROM THE REAR
OR SIDE OF THE APPLIANCE.
HOW TO SWITCH ON THE APPLIANCE
Open the valve on the gas bottle.
The regulator must be in the on position "". Press down completely on the
control knob (this will allow gas to flow from the pilot and burner). While holding
the control knob fully depressed, immediately press the piezo power button to
turn on the atmosphere analyzer.
If the device does not turn on, release the buttons. Wait 30 seconds and repeat
the procedure.
Once the pilot light is on, press and hold the regulator for 20 seconds. Then
release the control knob and turn it to the desired position according to the
required heat.
HOW TO OFF THE APPLIANCE
Turn the regulator to the ""position and close the gas valve completely.
Do not keep the controller pressed for more than 40 seconds.
Please do not move the stove when it is working.
16
