HumanTechnik lisa HWS10479 Instrucciones De Servicio página 12

Event icons
When triggered, the event icons will remain
visible for 40 seconds.
The icons symbolize:
Fire alarm
Baby
Flood alarm Colour: Blue
Telephone
Person call
Doorbell
Tones
There are different tones assigned to the
symbols. They are activated when the signal
selector switch (9) is in position 0 and 1. The
volume can be adjusted with the rotary vol-
ume control (7).
Status-LED
The receiver's battery status is indicated as
follows:
- A sufficient battery charge level of the
receiver is indicated by the status LED
flashing every 5 to 6 seconds in red.
- A low battery level of the receiver is in-
dicated by the status LED flashing every
two seconds in red.
Please recharge the receiver as soon as
possible (attach it to the power supply unit).
12 English
Colour: Red
Colour: White
Colour: Orange
Colour: Yellow
Colour: Green
Behaviour of the status LED when
the power supply unit is connected:
Charging the battery: The status indicator
lights up red. The red light is interrupted for
half a second every 6 seconds.
Battery is charged and the unit is ready for
operation: The status indicator lights up
green. Every 6 seconds, the status indicator
briefly lights up in red.
No batteries inserted: The status indicator
lights up with alternating green and orange.
Recalling the last alert, cancelling the
current alert
The tabletop receiver stores an incoming
signal for approx. 3 minutes. During this
time, you can call it up again by pressing the
function button »●« button to display the last
registered alert again.
You can also cancel an active indicated alert
by pressing this button.
AUX-socket and power connector
The »AUX«-socket (8) and the connector for
the power supply (10) can be found on the
rear of the receiver.
All Humantechnik modules can be connec-
ted to the AUX-output (vibrating pad, flash
module, vibrating contraption etc, available
as accessories). An indicated event will be
forwarded to the connected modules which
will then react accordingly.
The power connector is used to power the
receiver via the power supply unit. This is
used to recharge the batteries, but it can
remain connected for continuous operation
of the receiver.