Tabla de contenido
Idiomas disponibles
Idiomas disponibles
SIMPLE KEY USER GUIDE
BEFORE YOU BEGIN
Instructions have timing requirements. If you wait too long between steps, your vehicle's computer may time
out, requiring you to start over. Once you begin the pairing procedure, move at a quick and even pace.
1.
Find your vehicle's make, model, and year in the Vehicle compatibility in above. Turn the dial on the
EZ Installer to the position listed for your vehicle's make, model, year and the pairing process you are
performing.
a.
NOTE: If more than one dial position exists for your vehicle, try the PRIMARY dial position first. If you
are unable to successfully pair the key, try the ALTERNATE dial position listed for your vehicle.
2.
One of the pairing steps (Step 3 in all flow diagram) requires you to turn the inserted key to Ignition ON/
RUN position as shown in the figure below. This is the position before starting the car. (If there are no
markings, turn the key clockwise and stop just short of starting the engine)
3.
Enter the vehicle and close all doors.
TOYOTA IGNITION POSITIONS
4.
Keep original/already paired key and a new key with cut-blade with you.
5.
Proceed with the vehicle in PARK and the engine OFF.
12
SIMPLE KEY USER GUIDE
6.
Make sure to locate your vehicle's OBD port/diagnostic connector before you start. (It can be found in your
owner's manual). It is generally located under the dash.
7.
Remove the security label from the EZ Installer.
KEY PAIRING PROCESS: PAIR NEW KEY
NOTE: Some older vehicles might not require pairing a new key. Try starting the vehicle without completing this
process. If the vehicle starts and runs for 10 seconds, you do not need to pair the device. If the vehicle does not
start or does not keep running, start at step 1 below to pair the new key.
1.
Ensure the cable is plugged into the OBD port and any keys are removed from the ignition.
2.
Select position 1 for "dot" blades or position 3 for "G" or "H" blades on the EZ Installer.
3.
Insert a working master key and turn to the "on" position.
4.
Press and release the button on EZ Installer and you will hear a beep.
5.
After 30 seconds, the EZ Installer will beep twice. You will then have 12 seconds to complete step 6.
6.
Remove the key and insert the new key into the ignition, do not turn the key. Press and release the button
on EZ Installer.
7.
After 60 seconds, the EZ Installer will quickly beep three different pitches.
NOTE: If you missed hitting the button in time, or at all, the EZ Installer will start beeping repeatedly.
Unplug the device, remove the key, and start the process back at step 1. If you do not hear any sound, you
have started the pairing process. Continue below.
8.
Start the car to test the new key.
NOTE: Error beeps are a pattern of 3 / 4 or 5 distinct beeps at 1-sec intervals depending error codes. This
pattern will get played four times and then continue with faster beeps after that. Refer to the Frequently Asked
Questions section for more information about error beeps.
13
Tabla de contenido
