Getting Started - Emos E5111 Manual De Instrucciones

25 – time
26 – month
27 – outdoor humidity trend
Back and Top of the Weather Station (See Fig. 2)
1 – MODE button
CH button
SNOOZE/LIGHT button
UP button
DOWN button
ALARM button
Sensor Description (See Fig. 3)
A – LED of signal transmission from the
sensor
B – sensor screen
C – hole for hanging
D – battery cover
Attention
Only use 1.5 V alkaline batteries of the same type; do not use rechargeable 1.2 V batteries.
The lower voltage may cause both of the units to not function.

Getting Started

1. Connect the power adapter to the weather station and insert the batteries (3× 1.5 V AAA). Then
insert batteries into the wireless sensor (2× 1.5 V AAA). Make sure the polarity is correct when inserting the batteries to avoid damaging the weather station or sensor.
2. The pressure unit icon on the weather station's screen will start flashing – set it using the UP/
DOWN buttons and confirm by pressing SNOOZE/LIGHT.
3. The pressure value will start flashing – set it using the UP/DOWN buttons and confirm by
pressing SNOOZE/LIGHT.
4. The weather forecast icon will start flashing – set it using the UP/DOWN buttons and confirm
by pressing SNOOZE/LIGHT. The setting process will be automatically cancelled if you do not
press any button for 20 seconds.
5. The icon for wireless communication with sensor
weather station is searching for signal from the outdoor sensor. Place the two units next to
each other. If outdoor temperature does not appear within 3 minutes, the weather station will
stop searching for signal, the icon for wireless communication with sensor will stop flashing and
outdoor temperature/humidity will be displayed as --. If signal from the sensor is not detected,
repeat the process from step 1.
We recommend placing the sensor on the north side of the house. The range of the sensor may
decrease substantially in areas with a large number of obstacles. The sensor is resistant to dripping
water; however, it should not be exposed to sustained rain. Do not place the sensor on metal objects
as these would reduce transmission range.
The sensor can be placed vertically or hung on a wall.
A sensor with a wired probe can be placed in 2 ways:
1. The sensor is located in a room and the wired probe is led to the outside through a gap in the
window. In that case, the sensor measures outdoor temperature and indoor humidity.
2. The sensor and the wired probe are located outside. In that case, the sensor measures outdoor
temperature and humidity.
If the weather station screen shows the low battery icon
If the weather station screen shows the low battery icon
in the station.
Note: It may take up to 30 minutes since the insertion of batteries into the units before the station
begins correctly displaying all measured data and loads DCF time.
28 – outdoor humidity
29 – high heat index
30 – DCF signal reception
2 – hole for hanging
3 – stand
4 – battery compartment
5 – indoor temperature and humidity sensor
6 – power adapter socket
E – battery compartment
F – CH button (sensor channel number setting
– 1/2/3)
G – °C/°F button
H – wired temperature probe (1 m)
will start flashing, indicating that the
in field no. 5, replace the batteries in the sensor.
in field no. 17, replace the batteries
4