Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Fig. G
Shelf Support and Safety Strap
Instructions (Fig. H, I, J)
1. Each set of crossbeams
(3) shelf support straps
6
straps
installed.
2. Starting with the lowest set of crossbeams, place
a safety strap between the lower ridges of the
crossbeams where two sets of holes have been pre-
drilled. Thread a safety strap bolt
bottom of the pre-drilled holes and through the weld
nuts, and fully tighten with the included hex key
drill bit. Repeat this process for each strap for this set of
crossbeams. (Fig. H)
3. Repeat step 2 for the remaining set of crossbeams.
(Fig. H)
4. For each set of crossbeams, place three (3) shelf
support straps perpendicular to the crossbeams, and
insert each end into the slots on each ridge of the
crossbeams. (Fig. I, J)
Fig. H
Fig. I
6
4
will need to have three
5
and two (2) safety
7
up through the
4
7
6
4
5
Fig. J
Wall Anchor Assembly Instructions
(Fig. K, L, M)
WARNING: Serious injury or death can occur from
the rack tipping over. To prevent this, the rack must
be secured to a wall, especially in earthquake -prone
areas, or where surfaces are uneven, and where
children and/or pets are present.
CAUTION: Drywall anchors and anchor screws
14
or
are included with this rack; however, different wall
materials require different types of fasteners. Use
fasteners suitable for your specific type of wall. If you
are uncertain about what type of fasteners to use,
then please contact your local hardware store.
1. The wall anchor assembly
backside of the top crossbeam
the rack.
2. Take the U-shaped wall anchor and rock it up at an
angle to attach it to the bottom inner channel of the
crossbeam. Once attached, the back portion will sit
flush against the inside of the crossbeam. (Fig. K)
3. Once attached, the U-shaped wall anchor can be
moved from side to side (in between the two safety
6
straps
). This allows for it to be attached to a 2 x 4 in
the wall. (Fig. L)
4. The L-shaped wall anchor has two sets of four square
holes that allow you to adjust the distance of the rack
to the wall. Use two carriage bolts
12
nuts
to attach the L-shaped wall anchor to the
bottom of the U-shaped wall anchor. (Fig. M)
Fig. K
English
5
6
16
is installed on the
4
at the rear of
11
and two 10 mm
16
4
5
Tabla de contenido
