Before First Use; Cleaning, Care & Maintenance - Buffalo CH919 Manual De Instrucciones

EN

Before first use

1. Open the lid and wipe it clean.
2. Put a container beneath the spout, then pour warm water
through the ice jar to rinse the system thoroughly.
3. Empty the container and put it beneath the spout to
collect ice cubes.
Operation
1. Drop ice cubes into the ice chute. (Note: Suitable for
cubes up to 2x2x2 cm)
2. Close the lid in place.
3. Connect to the mains power supply and press the power
switch to start.
Warning: The blades of the crusher are self feeding!
Do not attempt to push cubes into blades with hand
or instrument.
Note: With the safety microswitch, the appliance
will stop automatically once the lid is opened during
operation.
4. After use, press the power switch again to turn Off. Then
disconnect from power supply.
Ice blockage
1. Should a large cube get blocked in the crushing unit, press the power switch to turn Off. Then unplug
the unit.
2. Pour warm water through the ice jar to melt ice blockage.
3. Re-plug and re-start the appliance.
Cleaning, Care & Maintenance
• Always turn off and disconnect the appliance from the power supply before cleaning.
• Pour warm water through the ice jar to rinse the system thoroughly.
• Wipe the appliance housing with a damp cloth. Dry well afterwards.
Troubleshooting
A qualified technician should carry out repairs if required.
Fault
The unit is not working
4
CH919_ML_A5_v1_20220622.indb 4 CH919_ML_A5_v1_20220622.indb 4
Probable Cause
Unit is not switched on
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Overheating protection is
activated after a long period
of intensive use
Lid with
microswitch
Ice jar
Spout
Suction feet
Solution
Check the unit is plugged in correctly and
switched on
Replace plug or lead
Replace the fuse
Check mains power supply
Wait at least 30 minutes and try again. Placing
the appliance in a cool place will reduce the
waiting time
Power switch
2022/6/22 15:53 2022/6/22 15:53