High Pressure; Low Pressure - G-Clean GC80922 Manual Del Operador

SELECTING THE RIGHT NOZZLE FOR THE JOB
See Figure 13 - 14.
Each of the nozzles has a different spray pattern. Before
starting any cleaning job, determine the best nozzle for the
job. Refer to the Nozzle Selection Guide for more information
about which nozzle to choose.
WARNING:
NEVER change nozzles without locking the lock out on
the trigger handle and never point the wand at your face
or at others. The quick-connect feature contains small
springs that could eject the nozzle with some force.
Failure to heed this warning could cause personal injury.
 Turn off the pressure washer and shut off the water
supply. Pull trigger to release water pressure.
To connect a nozzle to the spray wand:
 Engage the lock out on the trigger handle by pushing up
on the lock out until it clicks into the slot.
 Pull back the quick-connect collar.
 Push the nozzle into place in the spray wand.
 Push the collar forward so that the nozzle is secured
properly. Check to see that the nozzle is secure.
To disconnect a nozzle from the trigger handle once the
cleaning job is complete:
 Turn off the pressure washer and shut off the water supply.
Pull trigger to release water pressure.
ABRASIVE
Concrete, Brick, Masonry
Siding, Gutters, House
Fencing, Deck, Patio
Lawn Equipment, Boat, RV
OPERATION

HIGH PRESSURE

(NO SOAP WHEN USING THESE NOZZLES)
0º Red
GENTLE

 Recommended Nozzle
Page 11 — English
 Engage the lock out on the trigger handle by pushing up
on the lock out until it clicks into the slot.
 Pull back and hold the quick-connect collar.
 Remove the nozzle by pulling it from the quick-connect
collar. Place nozzle in the nozzle storage area on the top
of the machine.
USING THE HIGH PRESSURE HOSE
The high pressure hose features an outer covering that
provides strength to the hose. If the outer covering becomes
damaged, the hose must be replaced immediately. Do not
use a high pressure hose if the outer covering is damaged.
To prevent damage to the outer covering:
 Inspect the hose before every use.
 Fully unwrap and straighten hose before use.
 Do not allow the high pressure hose to be kinked.
 Keep hose away from hot surfaces and sharp edges.
 Do not pull unit by high pressure hose.
 Do not allow hose to be crushed or wrapped around
objects.
ATTACHING DETERGENT INJECTION HOSE
See Figure 15.
Before detergent can be used with this machine, the detergent
injection hose must be attached.
 Push the open end of the clear detergent injection hose
securely over the pump's fitting.
25º Green 40º White
 
 
 
 
Use With Caution for Certain Applications


LOW PRESSURE

(FOR SOAP OR
GENTLE RINSE)
Blue Soap Nozzle



