GYS POWER PACK 1300 Manual De Instrucciones página 12

Operating manual
When the POWER PACK1300 is charging, the display will also show:
- the charging power in Watts (W).
- the remaining recharge time in hours.
When the POWER PACK is in use, the display will also show:
- the power consumption in Watts (W).
- the machine's battery life in hours (the remaining charge will automatically update according to the device's power
consumption).
The LED display remains on continuously as long as the POWER PACK is active; when it is on charge or in use.
When all outputs are inactive, the LED display's backlighting will switch off after 30 seconds. The screen will turn off
permanently after one minute of inactivity and the machine will go into standby mode.
OPERATING THE DIFFERENT POWER-SUPPLY MODES
Before using the appliance for the first time, it is recommended to fully charge the battery to prevent a lack of
power from reducing the capacity of the POWER PACK.
1. Powering up: Press one of the buttons (3, 9 or 10) to activate the required output block(s).
The names of the active output blocks will appear on the display screen. From this moment on, the relevant outputs
are live, drawing power from the battery. The display screen will show the power consumption increasing.
2. Connect the chosen device, either to charge it or to use it. The power consumption will increase on the display
screen as well as the appliance's remaining battery life, which will be automatically updated.
3. Unplug the unit when you have finished charging or using it.
4. Switch off the active output block(s) by pressing the relevant button (3, 9 or 10) again.
The POWER PACK works until it reaches its average power (1300 : 1000 W, 1500 : 2200 W):
- in case the power is exceeded and to allow more equipment to operate normally, the POWER PACK
automatically regulates its AC output voltage (AC voltage decrease).
- In case the overload is too high, it goes into safety mode, the outputs are automatically cut off.
Be sure to disable the POWER PACK's output blocks. If they remain active, the POWER PACK will not go
into standby mode immediately and the outputs will continue to consume power.
If no connection to the output block has been made in the six hours following the activation of an output,
the output block will automatically switch off and only then will the POWER PACK to go into standby mode.
USING THE MACHINE IN BOOSTER MODE
!
RECHARGE THE POWER PACK's battery before and after each use.
1. Connect the jump-lead clamps (14) to the POWER PACK's connector (2), and make sure
the cable indicator is off.
2. Connect the red clamp to the vehicle's positive (+) battery terminal and the black clamp to
the negative (-) terminal.
3. To use the cable indicator, follow these instructions:
GREEN LIGHT ON:
12
Translation of the original
instructions
The connection is good and the
circuit is working, turn on the
vehicle's engine for an immediate
start-up.
RED LIGHT ON
with warning buzzer:
A beeping sound indicates a
polarity reversal. Reconnect the
clamps as explained in step two.
Wait for the green light to come on
before starting again.
POWER PACK 1300 / 1500