Changing A Programme; Cancelling A Programme; Switching The Machine Off - htech HTG69250 Instrucciones De Uso

7.1 Changing a Programme

Follow the steps below to change a
programme while in operation.
Open the door and press the
Programme Selection button to
select a new programme.
After closing the door, the new
programme will resume the
course of the old programme.
NOTE: Open the door slightly at first to
stop a programme before it is complete in
order to avoid water spillage.

7.2 Cancelling a Programme

Follow the steps below to cancel a
programme while in operation.
When the door of your machine
is opened, the most recently
selected programme will show on
the display.
Press and hold the Programme
Selection button for 3 seconds. '1' will
be shown on the Display.
The water discharge process will start after the
door of the machine is closed and will continue
for 30 seconds. A buzzer will sound 5 times
when a programme is cancelled.

Switching the Machine Off

"00" will be shown on the displaywhen a
programme is complete. A signal will also
sound 5 times. You can then switch your
machine off using the Power On/Off button.
Disconnect the plug and turn
NOTE: If any button is not pressed
on the ready state, the machine turns off
automatically after 15 minutes.
NOTE: Do not open the door before a
programme is complete.
NOTE: Leave the door slightly open at
the end of a wash programme to speed up
drying.
NOTE: If the door of the machine
is opened or the power is cut during
operation, the program will continue when
the door is closed or the power returns.
Infoled 2.1 (Model Dependent)
LED Indicator
Red, continuous
Red, flashing
Red, flashing
rapidly
Green, continuous
EN - I8
off the water tap.
State of the Machine
The machine is running a
program.
A program is cancelled.
The machine has a fault. Refer
to section "Automatic fault
warnings and what to do".
A program is finished.