Stove Support And Location; Gas Requirements; Leakage Test - Mercalor MT01555 Manual De Instrucciones

HEATER STAND AND LOCATION
The stove is primarily for outdoor use.

Always ensur e t hat adeq uate vent ilat ion is pr ovided

A lways keep an adequate distance from combustible material ,

ie 100 cm at the top and at least 100 cm at the sides.
The stove must be placed on a firm and level floor.

Never place the range in an explosive atmosphere such as areas 
where gasoline or other flammable liquids or gases are stored.
To protect the stove from strong winds, anchor the base securely

to the ground with screws.
 Use only propane or butane gas.
 The pressure regulator and hose assembly to be used must comply with local
standard codes.
 The installation must comply with local codes, or in the absence of local codes, with
 the standard for the storage and handling of liquef ied petroleum gases.
A dented, rusted or damaged cylinder can be dangerous and should be checked by

your cylinder supplier. Never use a cylinder with a damaged valve connection.

Never connect an unregulated cylinder to the stove.
Range gas connections are leak tested at the factory prior to shipment. A complete

gas tightness check must be carried out at the installation site, due to possible
mishandling during shipping or the application of excessive pressure to the stove.
Make a soap solution of one part liquid detergent and one part water. The soap

solution can be applied with a spray bottle, brush, or rag. Soap bubbles will appear in
the event of a leak.
The heater should be checked with a full cylinder.

Make sure the safety control valve is in the OFF position. Turn on the gas supply.

In the event of a leak, shut off the gas supply. Tighten leaking fittings, then turn on

gas supply and recheck.
Never do a leak test while smoking.


GAS REQUIREMENTS

LEAKAGE TEST

33
CEILING
100 cm
Off
Igniter
Fortification of base to the ground