Tabla de contenido
Idiomas disponibles
Idiomas disponibles
PREPARATION
BEFORE USE (refer Fig 1)
1.
Verify that the product and the application are compatible. If in doubt, contact Customer
2.
Before using this product, read the owner's manual completely and familiarize yourself thoroughly
with the product and its components, and recognize the hazards associated with its
3.
To familiarize yourself with basic operation, use the stamped end of the provided handle to
engage and turn the release valve:
a.
Clockwise,
until firm resistance is felt to further thread engagement. This is the 'CLOSED'
release valve position used to raise the
b.
Counterclockwise, but no more ½
valve position used to lower the load.
4.
Check that the pump operates smoothly and that the extension screw will thread up/down easily
before putting into service. Replace damaged or missing parts with factory authorized
replacement parts only. Only the handle assembly, oil filler plug, label, and owners manual are
available for this jack. Repair of this product may require special skills and knowledge and should
only be attempted by a factory authorized service
Bleeding / Venting Trapped Air
With the release valve in the OPEN position and with saddle in fully
lowered, locate and remove the oil filler plug. Insert the handle into the
handle sleeve; then pump 6 to 8 full strokes. This will help release any
pressurized air which may be trapped within the reservoir. Oil level
should be even with the bottom of the oil filler plug hole. Reinstall the oil
filler plug.
OPERATING INSTRUCTIONS
(Refer Fig. 1)
This is the safety alert symbol. It is used to alert you to potential
personal injury hazards. Obey all safety messages that follow this symbol
to avoid possible injury or death.
Lifting
1. Place vehicle in park with emergency brake on and wheels securely chocked to prevent
inadvertent vehicle movement.
2. Locate and close release valve by turning handle clockwise until firm resistance is felt to further
thread engagement. Center jack saddle under lift point.
3. Verify lift point, insert handle into handle sleeve and pump to contact lift point. To lift, pump
handle until load reaches desired height.
4. Transfer the load immediately to a pair of appropriately rated jack stands.
Use only the handle assembly provided by the jack manufacturer. The handle assembly provided
with this jack will safely engage the release valve and operate the handle sleeve. If the handle is
worn, operates abnormally, or will not positively engage the release valve, STOP. Discontinue use
of the jack until a factory replacement handle assembly can be acquired.
Lowering
1.
Raise load high enough to clear the jack stands; then, carefully remove jack stands.
2.
Slowly turn the handle counterclockwise, but no more than a ½ turn. If the load fails to
lower:
a)
Use another jack to raise the vehicle high enough to reinstall jack stands;
b)
Remove the affected jack and then the stands;
c)
Using the other jack, lower the load by turning the operating handle counterclockwise,
but no more than a ½ turn.
3.
After removing jack from under the load, push saddle down to reduce ram exposure to rust and
contamination.
load.
turn from the closed position. This is the 'OPEN' release
center.
9
Support.
use.
Tabla de contenido
