Care & Maintenance; General Cleaning; General Maintenance - sunjoe 24V-AGR100 Manual Del Operador

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

2. Select between forward and reverse (Fig. 5):
• Forward – Bit spins clockwise to dig into the ground.
• Reverse – Bit spins counter-clockwise to reverse out of
the ground.
Fig. 5
Red
LED
Mode selector
m
WARNING!
Always keep both hands on the handles.
Improper operation of the tool may result in serious injury.
3. Assume a secure stance and grip the auger handles firmly
with both hands. Position the auger away from your body
and at waist level. Ensure the auger is perpendicular (90°)
to the ground (Fig. 6).
Fig. 6
4. Push the safety lock and pull the trigger. Allow the bit a
couple of seconds to spool up before lowering it into the
ground (Fig. 7).
NOTE: Allow the screwing action of the auger flights to do
the work.
Green
LED
90°
Safety
lock
5. As the hole begins to fill up, periodically lift the auger out
to clear the debris.
6. Release the trigger and remove the battery when not in
use or before transporting the tool.
Care + Maintenance
m
WARNING!
Always switch the product off, remove the
battery, and let the product cool completely before inspecting,
cleaning, or performing any other maintenance task.
m
WARNING!
Only perform the repairs and maintenance
work described in this manual. Any other work must be
performed by a qualified technician.

General Cleaning

Keep the product clean. Remove any debris after each use
and before storage.
• Clean the product with a dry cloth. Use a brush for areas
that are hard to reach.
• Be sure to clean the air vents after every use with a brush
or compressed air.

General Maintenance

• Check for worn or damaged parts. Replace worn parts as
necessary or contact the Snow Joe
service center at 1-866-SNOWJOE (1-866-766-9563) for
repair before using the product again.
• After prolonged use, the bit will become worn and
lose some of their original effectiveness and should be
replaced.
Storage
• Remove the battery from the tool before storing.
• Store the tool and its accessories in a dry, frost-free, and
well-ventilated place out of the reach of children.
• The ideal storage temperature is between 50ºF (10°C) and
86ºF (30°C).
• We recommend using the original packaging or covering
the product with a cloth for storage to protect it against
excessive dust build up.
8
Fig. 7
Trigger
+ Sun Joe
customer
®
®
Tabla de contenido
loading

Tabla de contenido