7. OPERATION
7.1 lnsert and remove the battery pack (sold separately)
WARNING! Before inserting or removing the circular saw's battery, make sure the
appliance is switched off.
a) To insert the battery pack, align the battery pack with the circular saw base and slide the battery
pack into the circular saw, so that the battery pack is locked in position.
b) To remove the battery pack, press the battery's release button and pull the battery pack off at the
same time.
7.2 General cutting
a) Check and make sure the workpiece is held securely.
b) Press the lock off button and the variable speed onloff trigger switch at the same time to turn on
the circular saw.
c) Put the base plate against the workpiece.
d) Hold the circular saw with both hands.
e) When the saw blade reaches full speed, cut the workpiece slowly.
f) Release the variable speed onloff trigger switch to turn off the circular saw. The saw blade will
continue rotating for a few seconds after the circular saw has been switched off.
7.3 Laser beam
WARNING! Before inserting or removing the circular saw's battery, make sure the
appliance is switched off.
a) Mark the cutting line on the workpiece.
b) Adjust the cutting angle and cutting depth as needed.
c) Put the circular saw on the workpiece.
d) Press the laser onloff switch (13) to turn on the laser module.
e) Align the laser beam with the mark on the workpiece.
f) Turn on the circular saw and cut the workpiece slowly. Keep the laser beam on the cutting line.
g) Turn off the laser beam after cutting.
7.4 Dust extraction
A vacuum cleaner can be connected to the dust extraction port (1) either directly ar using an adap-
tar to collect the saw dust.
8. CLEANING, MAINTENANCE AND STORAGE
WARNING! Remove the battery before any cleaning, maintenance or storage.
8.1 Cleaning
a) Keep the ventilation slots free from dust and dirt to prevent overheating.
b) Regularly clean the circular saw's housing with a soft cloth, preferably after each use. lf the dirt
9