Using The Timer; Cleaning, Care & Maintenance - Buffalo DF825 Manual De Instrucciones

7. To turn appliance off, just press the
On/Off key.
• To lock the control panel, press the lock key
once. To unlock, press and hold the lock key.
• This appliance has an overheat protection
function. If the pan becomes too hot the
appliance will switch off, a buzzer will sound
and the display will show "E2". Should this
happen, allow the appliance to cool before
restarting.
• Fan will continue to run while the glass surface
temperature is over 80°C.

Using the timer

• When in Power or Temperature mode, press
the TIMER key to enter/view the timer.
• Press the Increase or Decrease key to change
the timer.
Function Level
Timer 0 to 180min
• When the set time expires, the appliance will
switch off automatically.
Troubleshooting
Fault
The unit is not working
"E0" on Display
"E1" on Display
"E2" on Display
"E3" on Display
DF825_ML_A5_v2_20220713.indb 5 DF825_ML_A5_v2_20220713.indb 5
Cleaning, Care &
Maintenance
•
•
•
•
Increments Default
5min 0min
Probable Cause
The unit is not switched on
Plug or lead is damaged
Fuse in the plug has blown
Power supply
Unsuitable cookware
Unsuitable cookware / no
cookware
Appliance has overheated
Temperature of pan is too
high (Pan is dry or empty)
Input voltage is too high/
low
Disconnect from the power
supply and allow the appliance
to cool before cleaning.
Use warm, soapy water and a damp cloth to
clean the appliance.
DO NOT use abrasive cleaners or pads.
Dry thoroughly after cleaning.
A Buffalo dealer or qualified technician should
carry out repairs if required.
Solution
Check the unit is plugged in correctly and
switched on
Replace Plug or lead
Replace the plug fuse
Check power supply
Replace with suitable cookware
Replace with suitable cookware
Check ventilation slots for blockage. Allow to
cool before attempting to use again.
Remove cookware. Allow to cool before
attempting to use again.
Make sure the mains power supply is suitable
for the appliance.
EN
5
2022/7/13 15:31 2022/7/13 15:31