Sentiotec PRO-C3 Manual De Instrucciones página 2

Additional sheet for instructions for use
b. Turn the lower knob to the right
► In the lower display "door" appears
3. Exiting the technician menu (Longpress on the lower knob)
10. Operation
Activating „Standby for remote operation" with door sensor
1. Turn the top knob to the remote start symbol
► In the lower display „oFF" appears
► The remote start symbol flash.
2. Press the lower knob
► A countdown of 30 seconds is shown in the lower display. During this time, the door can be opened/
closed as often as you like. After the countdown has expired, the door must be closed!
► In the lower display „rc" appears
► The sauna control is now ready to be started and stopped once via a remote start signal = Mode
„Standby for remote operation"
Door is opened - warning „door" appears in the display
- at mode „Standby for remote operation":
To continue the mode, the door must be closed and the lower button has to be press two times.
► The countdown (30 sec.) is shown again in the lower display.
- in operation or enable remot start output (for coinoperated unit or door sensor system):
The acknowledgment takes place automatically when the door is closed.
11. User programm
The settings in the user programs has been added with the function runtime (hours) . A runtime of 2 hours is
EN
stored in all preset user programs and can be changed as described under „Creating your own user programs".
additional to PRO C3:
Setting option up to the set heating period limit - see starting up function selector switches 1
and 2 (standard setting 6 hours)
8.2. Settings in the technician menu
Setting the runtime of the post-drying programme
1. Open the technician menu (press the lower bottom knob and the ON/OFF switch at the same time)
2. Turn the top knob to the humidity symbol
► The humidity symbol lights up.
► In the top display „SIn" appears.
► In the bottom display „OFF" appears
3. Press the lower buttom
► In the top display„dry" appears
► In the bottom display „t60" appears
4. Turn the lower buttom (Selection 0 - 60; 0 = post-drying progamm off , 60 = maximum runtime in minutes)
5. Exiting the technician menu (Longpress on the lower knob)
p. 2/2