Tabla de contenido
Operation
• Turn on the compressor and fill it.
• Regulate the air compressor output pressure to 75 PSI and
110 PSI
WARNING
The tool operates with this pressure
range. If operating with a higher pressure ranges the useful
life of the tool will be decreased.
• Load the cartridge as indicated on page 7.
CAUTION
• Use a piece of scrap wood to verify the
tool works correctly.
Depth regulator
The driving depth of the nails is adjustable. To adjust the
depth, use the transmission depth adjustment wheel (D).
CAUTION
Disconnect the tool from the air supply
before attempting to disassemble any parts.
• Turn the depth adjustment wheel left or right to change
the driving depth
• Reconnect the tool to the air supply
• Insert a test nail after each adjustment to the desired
depth.
8
ENGLISH
• Having your finger away from the trigger position the tool
and press the contact lock against the surface to be used (A).
• Without lifting the tool press the trigger to shoot (B).
• Immediately release the trigger and lift the tool (C).
• Position the tool back for subsequent shots.
• In case the nails are not penetrating deep enough, slightly
lift the air pressure until reaching the right penetration force.
WARNING
• Or, slowly turn the depth control (D) until gaining the
expected penetration force.
A
Start Up
Remember not to exceed 110 PSI
B
D
Too Deep
Flush
C
Tabla de contenido
