Depth Adjustment - VATTON 49880 Manual De Instrucciones

EN
INSTALLING BIT
1. Pull the locator firmly and have it get separated from
tool.
2. Install bits on the magnetic bit holder.
3. Install the locator by pushing it back to tool. Make sure
there's no gap between locator and tool.
C1
C3

DEPTH ADJUSTMENT

Screwing depth can by adjusted by turning the locator in
different direction.
D
To drive a screw with a suitable depth, please adjust loca-
tor and make distance between tip of the locator and the
screw head is around 3mm (see figure E). If drive depth is
still not suitable, keep adjusting locator until it meets your
requirement.
E
C2
C4
FASTENING AND RELEASING SCREWS
1. Move reversing lever to right, tool rotating clockwise to
fasten screw.
2. Move reversing lever to left, tool rotating counterclock-
wise to release screw.
3. If keep reversing lever in middle, the trigger is locked
and tool cannot be activated.
On the right In the middle
position
SCREW DRIVING OPERATION
1. Assemble bit into tool locator (take reference of insta-
lling bit with figure C).
2. Place the point of the screw on the work piece surface.
3. Pull the trigger and apply pressure to the tool and start
fastening the screw. Tool speed is increased by increasing
pressure on the trigger. Once the screw reaches the set
depth, bit will stop rotating.
Apply
pressure
on tool
WARNING!
When fitting the screw onto the point of the bit,
be careful not to push in on the screws. If the
screw is pushed in, the clutch will engage and the screw
will rotate suddenly. This could damage a work piece or
cause an injury. Make sure that the bit is inserted straight
in the screw head.
4
F
On the left
position position