Emos P5611OT Manual De Instrucciones página 12

Temporary Change of a Set Programme
In standard mode, where temperature is controlled by a selected programme, pressing
the button switches from the currently set programme to comfort or economy
mode. When the selected programme is switched over in this way, the
displayed together with the selected control mode icon.
This setting will cancel automatically upon the next temperature change in the
programme.
Temporary Change of Temperature Setting
In standard mode, where temperature is controlled by a selected programme, you
can press the or
temperature is changed, the newly set temperature will be displayed together with
the icon, with the
exit the temperature setting mode. If no button is pressed for 10 seconds, setting mode
ends automatically. This setting will cancel automatically upon the next temperature
change in the programme.
Note: If you wish to use the manually changed temperature for an extended period of
time, we recommend doing so in programme no. 1 or 2.
Calibrating Room Temperature
Long-press the "P" button. "CAL" will appear on the screen and the set temperature
value will be flashing.
Repeatedly press the
0.5 °C increments).
Press the "P" button to confirm the setting.
Calibration of room temperature is used, for example, if the thermostat shows 21 °C
but you want it to show 20 °C. In that case, the calibration value should be set to -1 °C.
Anti-Freeze Mode
1. Press the and
(for heating mode only).
will not be displayed.
2. Press any button (except
3. Default temperature for anti-freeze mode is 7 °C.
Setting OpenTherm Parameters
Applies only to heating mode.
1. Long-press the
the left corner and water temperature in the OpenTherm boiler will appear in
the centre (if the thermostat is not receiving a temperature reading, "---" will
be displayed instead).
button to override the current temperature setting. When the
and icons disabled. Press any button (except
or button to adjust the temperature (-3.0 °C to 3.0 °C, in
buttons simultaneously to activate the anti-freeze mode
and will appear on the screen and
) to end anti-freeze mode.
button to access OpenTherm settings. "01" will appear in
12
icon is
or ) to
and