Assembly; Adjusting The Strap; Operating The Equipment - Jacto GM-1 Manual Del Operador

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

4.1. Assembly

Jacto GM-1 Granular Spreader can be used with the 1-liter tank, or the 18-liter
tank, according to your need. To install the tanks, follow the steps below:
• Insert the 1-liter tank and screw it as shown in the figures.
1)
2)
ATTENTION!
Do not over-tighten any parts.
• For use with the 18-liter tank, first, remove the tank lid as shown in the figures
below:
1)
• Run the hose through the clamp, fit it securely into the tank outlet, and tighten
the clamp:
1)
tank outlet
clamp
hose
• Insert the other end of the hose through the fairing and screw it back onto
the tank.
10/25
2)
2)
• Then, insert the adapter into the spreader and screw it.
OBS.: Before inserting the adapter, align the two screw holes as shown in the fig-
ure.
• Next, insert the hose through the clamp, fit it securely, and tighten the clamp.
1)
clamp
hose

4.2. Adjusting the strap

The equipment tank has an anatomical shape, providing greater comfort to the
operator. With a simple strap adjustment, the operator can position the equip-
ment correctly on his back.
• Pull the straps down to adjust them as needed.
A
pull strap
down

5. Operating the equipment

ATTENTION!
Do not operate your equipment if parts are missing.
Replace any defective parts before use. Misusing the
equipment can result in malfunction and personal injury.
ATTENTION!
When operating the spreader, wear personal protective
equipment (PPE), such as boots, gloves, protective
eyewear, and a face mask.
screw
adaptor
2)
B
strap lock
Tabla de contenido

Solución de problemas

loading

Tabla de contenido