Before Commissioning; Commissioning - Comedes LTR 100 NEO Manual De Instrucciones

Ocultar thumbs Ver también para LTR 100 NEO:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 73
Keep at least 50cm distance around the device to walls and objects. Make sure that the air
outlet is free and that there are no curtains or textiles above it.

Before commissioning

After unpacking the device, check it for completeness and possible transport damage
to avoid hazards. In case of doubt, do not use it, but contact our customer service.
You will find the service address at the end of these instructions.
Your device is packaged to protect it from damage in transit.
Carefully remove the device from its sales packaging.
Remove all packaging.
Clean the device and all accessories from packaging dust residues according to the
information in the chapter "Maintenance".

Commissioning

Before connecting the mains plug, check the device and especially the cable for damage. The
device may only be operated with a faultless mains cable.
Plug in the mains cable and switch on the device with the on/off switch.
CAUTION: Always allow the unit to run for at least 35 minutes before turning it off and never
turn it off or on continuously. There would be a risk of compressor damage.
After switching off, leave the Comedes LTR 100 NEO to stand for at least 3 minutes without
moving the appliance so that the water in the drip tray can drain off completely.
The higher the humidity in a room and the higher the temperature, the better the Comedes
LTR 100 NEO can dehumidify the air. Therefore, the compressor will generate heat and heat
the room air. This is quite normal and does not need to worry you.
ATTENTION: Always open the air outlet flap before starting the unit.
Note: Before using the device for the first time, we recommend that you operate it for 5-10
minutes with the window open in order to remove any production-related residues. Any odour
that may occur is normal and disappears after a short time. This is not a malfunction of the
device. Ensure adequate ventilation.
On / Off switch:
When you plug in the unit, a beep sounds and the "POWER" LED lights green.
Open the flap of the air outlet before switching on the unit.
Press the On/Off switch to turn on the unit; the dehumidifier will start in continuous operation
with high air flow.
Press the On/Off switch again to turn off the unit. The compressor switches off immediately,
EN-9
min. 50cm
min. 50cm
min. 50cm
min. 50cm
www.comedes.com
Tabla de contenido
loading

Tabla de contenido