Putting The Device Into Operation - Emos P5623 Manual De Instrucciones

Switching Unit Wiring Diagram
Pump/Motorised Valve Connection Diagram
Pump/
valve
Floor Heating Connection Diagram
Connected
device
Boiler Connection Diagram
Boiler
Pre-installed wire coupler will not be connected.
Expansion Valve/Electric Drive Connection Diagram
Connected
device

PUTTING THE DEVICE INTO OPERATION

Pairing the Control Unit with the Switching Unit
Both thermostat units must be paired before first use.
Pairing enables transfer of information between the control unit and the switching unit.
Setting is done via automated pairing (self-learning).
1. Fit the thermostat gently onto the stand.
Connect the USB power supply with micro USB cable to 230 V mains and plug the cable into the
stand.
2. Correctly connect the switching unit to voltage supply, turn the main switch to the position and
long-press (for at least 10 seconds) the M/A button; a green diode will begin flashing.
3. Press on the thermostat (transmitter), then press -, which sends you to TECH SET settings.
2× press the > button, so that LEAr appears on the screen.
11