Product Characteristics; Safety Instructions - LUND 68193 Manual Original

GB

PRODUCT CHARACTERISTICS

Electric kettle is designed for water heating and boiling. Thanks to its high power it is possible to boil water quickly. Detachable
base ensures convenient and safe usage of the kettle. The product is intended only for home use. Correct, reliable and safe
operation of the product depends on proper operation, therefore:
Before starting product operation, please read this manual and keep it.
The supplier does not assume any liability for damages resulting from failure to follow safety regulations and recommendations
specifi ed in this manual.

SAFETY INSTRUCTIONS

Note! Product may heat up to high temperature during operation, be cautious when handling it. The product should be held using
only the handle.
SAFETY INSTRUCTIONS
Note! Product may heat up to high temperature during operation, be cautious when handling
it. The product should be held using only the handle.
Recommendations for the product transportation and installation
The product can be placed only on a hard, fl at, level and non-fl ammable surface resistant
to high temperatures. Substrate should withstand the weight of appliance itself together with
water poured into it.Provide at least 10 cm space around product's side walls, do not place
any materials not resistant to high temperature above the product. This will allow for proper
product ventilation. Do not place the product near edges e.g. of a table. Do not put anything
on the product. It impairs air circulation and may be a cause of product damage, as well as
fi re. Do not place the product near fl ammable materials, e.g. curtains or drapes. Do not
place any electrical appliances over the product. Steam is released during operation of the
product, which may cause a short circuit of electrical installation resulting in electric shock. It
is forbidden to drill any hole in the product, nor any other product modifi cation not described
herein. Carry the product with hot water by grasping the handle and lifting up from the base.
Do not carry the hot product along with the base. Do not displace the product by pulling the
cable cord. Temperature at the place of product installation and use must stay within the
range +10 C ÷ +38 C and the relative humidity must be less than 90%, without steam
O O
condensation.
Recommendations for connecting the product to power supply
Before connecting the product to power supply, make sure that the voltage, frequency, and
capacity of mains supply correspond to values shown on the product rating plate. Plug must
fi t into the socket. It is forbidden to modify the plug or socket in order to fi t each other.Product
must be connected directly to a single power outlet. It is forbidden to use extension cords,
socket-outlet adapters and double power outlets. Power supply circuit must be fi tted with a
protective conductor and at least 16 A protection circuit. Avoid any contact of power cord with
sharp edges and hot objects and surfaces. When operating the product, the power cord must
always be fully unwound and its position may not interfere with the operation of product. Lay-
ing of power cable cannot result in tripping hazard. Power outlet should be located in such a
place to allow always the possibility of quick disconnecting the plug of power cord supplying
O R I G I N A L I N S T R U C T I O N S
10