Main Parts Of The Product; Preparation Before Use - Hendi 208304 Manual Del Usuario

or electrical connections with grounding wire. The connections
must be properly installed and grounded.

Main parts of the product

(Fig.1 on page 3)
1. Fill opening of water reservoir
2. Filter holder
3. Coffeepot
4. Keep warming button (upper warming plate)
5. On/OFF button: Boiling the water & keep warming of lower
warming plate
6. Upper warming plate
7. In-use indicator lamp
Remark: The content of this manual applies for all listed items
unless specified otherwise. The appearance may vary from the
shown illustrations

Preparation before use

• Remove all protective packaging and wrapping.
• Check that the device is in good condition and with all ac-
cessories. In case of incomplete or damaged delivery, please
contact the supplier immediately. In this case, do not use the
device.
• Clean the accessories and the appliance before use (See == >
Cleaning & Maintenance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and heat resistant
surface that is safe against water splashes.
• Keep the packaging if you intend to store your appliance in
the future.
• Keep the user manual for future reference.
NOTE! Due to manufacturing residues, the appliance may emit
a light odor during the first few uses. This is normal and does
not indicate any defect or hazard. Make sure the appliance is
well ventilated.
Operating instructions
• Remarks: With two glass decanter of 1,8 litre & 25 coffee fil-
ters included.
1. Place the coffee machine on a stable flat surface.
2. Put the filter in the holder.
3. Open the lid of the water reservoir. Fill the coffee pot with
cold water and pour it in the water reservoir. Then, close the
lid. Wait 1 minute for the water to force the air out of the
appliance.
4. Place the empty glass decanter on the lower warming plate.
5. Connect the power plug to a suitable electrical power out-
let.
6. Press the On/OFF button once to switch ON the appliance
and RED indicator lights up to indicate that the boiling pro-
cess has started.
7. HOT WATER will soon start dripping into the pot.
8. When all of the water has passed through the machine, red
indicator light will switch off.
9. Press the On/OFF button to switch off the appliance.
10. Repeat steps 5 to 9 a few times to clean the appliance thor-
oughly before making coffee for the first time.
11. It is normal for steam to escape during this process and for
the dripping water to make gurgling sounds.
12. Let the appliance cool down for several minutes.
13. Remove the glass decanter from the warming plate. Hold it
only using the handle. Danger of burns!
14. Discard the water from the first few boiling cycles to remove
any residues from the manufacturing process.
15. Clean the appliance afterwards.
Note: Never pour hot water in the water reservoir.
Brewing coffee
Note: To brew coffee with this appliance, a coffee filter is re-
quired. Coffee filters Ø 25cm (x25, supplied). Do not use this
appliance without coffee filter in place.
To make coffee follow these steps:
1. Put the coffee filter (supplied) inside the filter pan. Add the
desired amount of ground coffee, depending on your taste.
The recommended amount is 75-90 gm per pot of water
(1.6-1.8 litre).
2. Place the filter pan in the holder.
3. Fill the coffee pot (glass decanter, vacuum pot or thermos
depending on model type) with the desired amount of water
and pour it in the water reservoir. Then, close the lid of the
water reservoir.
4. Place the empty glass decanter on the lower warming plate.
5. Connect the power plug to a suitable electrical power out-
let.
6. Press the On/OFF button once to switch ON the appliance
and RED indicator lights up to indicate that the brewing pro-
cess has started.
7. After some time coffee will start to drip into the coffee pot.
8. When all of the water has passed through the machine, red
indicator light will switch off.
9. In order to keep warming of the glass decanter, the appli-
ance must remain switch ON.
10. When served, remove the glass decanter from the warming
plate and pour the coffee carefully to ensure that hot coffee
is not spilled. Hold the handle of the glass decanter only.
Danger of burns!
11. It takes about 5 to 6 minutes to brew one glass decanter
of coffee.
12. There is another warming plate at the top. You can put the
ready glass decanter on it & press keep warming button
to operate & keep it warm. So that you can brew another
glass decanter of coffee at the same time using the lower
warming plate.
13. The appliance has an overflow tube to allow extra water in
the reservoir to escape, but since the coffee pot can hold
only 1.8 litres of water we recommend that you never fill the
reservoir with more than 1.8 litres of water.
14. Some water will always be left in the machine and in the
tubes. If you do not use or move the appliance for a long
time, it is best to empty the appliance and clean it before
storing it.
15. If you have emptied the appliance (as recommended in no.
10 above), before using it again you should repeat steps 1-7
of Preparing the appliance for use.
16. If you haven't used the appliance for a short time, rinse it out
with clean water before use.
Do not forget to turn the appliance off after use.
GB
7