Ryobi RTS23 Manual De Instrucciones

WARNING:
This insert sheet is not a substitute for reading the operator's manual. To reduce the risk of injury, user must read and
understand operator's manual before using this product.
INSTALLING STAND LEGS
See Figures 1 - 2
(Replaces figures 8 - 9, page 16 in the operator's manual).
Many of the leg stand parts are movable. All hardware must
be tightened securely but not so tight that the leg stand won't
open and close. For easier assembly, match letter to letter, then
install hardware.
Locate the following parts:
Stand leg .........................................................................4
Lock Nut (M8) ..................................................................2
Self-tapping Screw ..........................................................4
 Assemble each side separately. Install all legs with feet
pointing outward.
 Carefully remove the bolt from the support bracket while
holding the pivot plate in place. Set the bolt aside.
 Insert front stand leg labeled "A" into the end tube of the outer
stand support bracket labeled "A" and insert the front stand
leg labeled "C" into the end tube of the inner stand support
bracket labeled "C". Repeat with rear stand legs labeled "B"
and "D".
 Align the hardware holes of the support brackets, legs and
pivot plates. Insert the bolt through all pieces and secure
with a lock nut. Tighten the nut using a 13 mm wrench. Then
loosen nut slightly to allow legs to pivot freely.
NOTE: Do not overtighten as this will not allow the stand to
move freely.
 Locate the screw holes in the legs, near the pivot plates.
 Using a Phillips screwdriver, insert self-tapping screws
through each of the holes.
Fig. 1
RTS23/RTS23T
ADDENDUM
ADDENDA / APÉNDICE
LETTERS
Fig. 2
FRONT STAND
LEG ("A")
LOCK
NUT
PIVOT PLATE
INNER STAND
SUPPORT
BRACKET
SELF-
TAPPING
SCREW
PIVOT
PLATE
SELF-
TAPPING
SCREW
FRONT STAND
LEG ("D")
HOLES
BOLT
OUTER STAND
SUPPORT
BRACKET
SELF-
TAPPING
SCREW