Tabla de contenido
Cutting with cutting wire
• As the grass is cut, the cutting line will wear out and
eventually come off. To release more line from the reel,
push the string trimmer down a little so that the ground
presses the retaining cap against the reel and releases
more line. The excess string will be cut off by the guard
blade, at this point stop pushing the string trimmer against
the ground to avoid wasting string.
• When cutting tall weeds or grass, cut them gradually, do
not try to cut them all at once from the base, as the
residue may jam the cutting head or cause you to lose
control of the string trimmer.
Cutting wire spool
• With the string trimmer off and the batteries removed,
remove the reel retaining cap (A) by pressing the release
buttons by hand.
• Remove the empty spool, make sure it is clean and has
no damaged or worn parts.
• Cut a piece of thread 10 ft long.
• Fold the thread in half, and insert it into the notch.
• Take both threads and wind them in the direction of the
arrow marked on the spool. Make sure that each piece of
thread is twisted in its respective section (top and bottom).
Do not tangle too much yarn, after tangling, there should be a
minimum distance of 6 mm between the edge of the spool
and the tangled thread.
• Leave approximately 6" of both untangled threads.
• Place the spool back in its cover (H) by thread the ends of
each thread through the holes in the cover.
• Attach the retaining cap and push down until the two
retaining latches click back.
• Recommended for use with 2.4 mm diameter cutting
wire model (HDU-12-95, HTA-95B, HTA-95, HLB-95,
HTR3-95)
ENGLISH
12
Star Up
A
H
Tabla de contenido
