Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CLEANING FOAM WET FILTER
1. With the removed power head in an upside-down position, carefully remove the foam wet filter
(Fig. 4).
2. Use a mild soap and water solution to wash the foam wet filter and rinse with clean water (Fig. 5).
3. Allow the wet filter to air dry for 24 hours before installing onto the filter cage.
WARNING:
TROUBLESHOOTING.
PROBLEM
The wet/dry Vacuum will not
operate.
The dust comes out from the
motor cover.
Reduced efficiency and motor/
speed vibration.
TROUBLESHOOTING
TO REDUCE THE RISK OF ELECTRIC SHOCK, UNPLUG BEFORE
POSSIBLE CAUSE
No power supply.
Faulty power cord.
Collection tank is full.
Switch in the wrong position.
The cartridge filter is missing or
damaged.
Vacuum has been used to
collect fine dust, such as dry
wall dust, fireplace soot, or ash,
without a fine dust filter.
There are blockages in the
nozzle or hose, or the collection
tank inlet.
The cartridge filter is clogged by
fine dust.
Check power supply, cord,
breakers, and fuses.
Unplug and check the power
cord. If damaged, have it
repaired by a professional.
Empty the collection tank.
Press the ON 'I' button on the
power head.
Attach or replace the cartridge
filter.
Remove the standard cartridge
filter and install the appropriate
fine dust cartridge filter.
Unplug and check nozzle, hose,
and collection tank inlets for
blockages.
Take off the filter and clean it or
install a new cartridge filter.
15
SOLUTION
Tabla de contenido
