Placing In Service - T.I.P. SBS 36 Traducción De Las Instrucciones De Uso Originales

•
Cut off your desired length (approx. 1 m) of hose (4) — for installation as a suction hose — and plug it with one side
on the connection for in-flowing water (IN) (control unit) and with the other side on the connection to the filter (3).
•
Now cut off about 15 cm of the accompanying hose (4) and plug it with one side on the connection to the control unit
for out-flowing water (OUT) and the other side on the connection of a T-fitting (5).
•
Now, using the suction cups, place the filter (3) in the side of your water container as far as possible beneath the
water surface — but somewhat above the floor so that no dirt or other sediment can be sucked in.
•
Cut off about 10 cm of the hose (4) and plug it onto one side of a T connection (5).
•
On the other end of the piece of hose (4), plug the check valve (8). Make sure that the "OUT" marking on the check
valve (8) points to the hose (4). This prevents water running uncontrollably when the pump stops.
•
Plug the hose (4) onto the last free side.
•
The hose (4) can be freely cut according to your needs and the drip outlets (7) can be installed entirely individually.
•
Disconnect the hose (4) at any point and install one of the T connections in between (5).
•
Cut off a piece of hose (4) and plug it onto a T connection (5).
•
Lastly, put the drip outlet (7) onto the end of the hose piece (4).
• Repeat this until all necessary drop outlets (7) are handled.
•
Arrange the drip outlets (7) individually on your plants according to your needs and fix them in place using the
attached hose holders (6).
•
If the end is not equipped with a drop outlet, seal it with the enclosed sealing plugs (9).
•
Now the solar watering set is ready for use and can be used.
•
Never connect the pump to a mains plug, it is only designed for 6 V DC battery operation.

7. Placing in service

Comply with the safety measures! Never short circuit the battery that is integrated into both poles in the control
housing! The device's connection cables must not be damaged!
The batteries must be completely charged before switching on the device.
In addition, the solar-powered device must be charged in direct sunlight for a minimum of 4 hours after
installation. The pump must not be switched on during the initial charging process. Make sure that there are no
shadows on the solar panel, otherwise the charging capacity will be greatly reduced. If the device has not been
operated for a long period of time, repeat the measures described above.
Low battery:
If the battery is empty, the solar panel must be charged in direct sunlight for at least 4 hours and watering must
not be switched on frequently.
3
9