Primo T355 Manual Del Usuario página 3

WHAT YOU'LL NEED TO HAVE HANDY
1. Primo Water Dispenser
2. Phillips screwdriver (not included)
3.
Wall anchor (included)
4. Screw (included)
5. Bracket (included)
6. Drip tray (included)
7. Primo water bottle (Ideally suited to our 10L,11L,15L and
18L bottles - sold separately)
QUICK START GUIDE
Note: Your dispensr should be stored upright for at least
24 hours prior to use.
1.
2. Postition dispenser so the back is at least
4 inches (11cm) from wall and there are
at least 4 inches (11cm ) of clearance on
both sides.
3. Clip wall bracket onto rear right corner of
dispenser as shown. Using a Phillips
screwdriver [not included], install plastic
anchor directly into drywall or sheetrock.
Secure by installing screw through the
bracket into the plastic anchor.
Slide drip tray into place.
4.
5.
Grab a bottle of Primo water
[sold separately] and remove the
sticker from the cap. Carefully lift
bottle and insert onto probe. Apply
slight pressure if needed to ensrue
that the cap is fully pierced. Water
will begin to flow into the reservoirs
causing air bubbles to rise in the bottle.
6. Plug dispenser into your household
plug socket. Specification for mains supply
(voltage, frequency) 220-240V ~ 50/60Hz.
7. Turn on desired functions by flipping
the switches on the back of the
dispenser to the ON position.
Blue - nightlight
Green - chills water
8. Once the dispenser has stopped filling the
internal tanks, dispense and dispose of at
least 2 pints (1L) of water from the cold
and ambient spouts.
9. Your water will be ready to dispense fully chilled in
approximately 1 hour.
10. Register your dispenser at primodispensers.com to
activate your extended warranty.
Blue Green
1L